Technical Data - Jonsered HT2258 Li Manual De Usuario

LED screen
LED 4 is green
LED 1 is red and LED 2 is
green, battery pack does not
charge or operate correctly in
product
RED LED comes on, LED 2
is green and flashes during
charging or when the battery
pack is in the battery charger
RED LED flashes and LED 2
flashes green when the bat-
tery pack is installed.
Motor specifications
Motor type
Motor voltage
Motor power
Battery and charger specifications
Default battery pack type
Default battery charger type
Noise and vibration data
Equivalent vibration level (ahv, eq) front handle.
See Note 1.
Equivalent vibration level (ahv, eq) rear handle.
See Note 1.
Sound power level, guaranteed (LWA). See Note
2.
Sound power level, measured. See Note 2.
Sound pressure level at operator's ear. See Note
3.
10
Possible faults Possible steps
Battery pack is Remove the battery pack from the battery charger and install in
overcharged the product. Operate the product. Battery charger may be de-
fective. Speak to an approved service center.
Battery pack failure Remove battery pack from the product. Do not charge. Battery
pack is damaged and must be replaced. Speak to an approved
service center.
Internal battery Move the battery charger and battery pack to a location where
tempature is too the internal temperature of the battery pack can be between
low or too high for 5°C (41°F) and 45°C (113°F).
charging
Internal battery The internal temperature in the battery must be between -15°C
temperature is too (5°F) and 70°C (158°F). The environment temperature in the
low or too high battery pack is too low or too high.
•
•

TECHNICAL DATA

unit
V (DC)
W
m/s
m/s
dB(A)
dB(A)
dB(A)
If the battery pack is too cold from the ambient environ-
ment, move the battery pack and battery charger to a warm
environment.
If the battery pack is too hot, especially after operation,
move the battery pack and battery charger away from the
hot environment.
HT2258 Li (BHT58VJN)
Brushless
58
400
140Li
275Ci
2
2.497
2
2.884
96
94.95
84.06
668 - 002 - 13.06.2018