Speedlink POWERSTRIXX ULTRA 5.1 Manual De Instrucciones página 12

batteries in the remote control, note that the spring of the contact
plate inside the battery compartment points downwards.
3. Remove old batteries and insert new batteries in the battery
compartment as indicated by the markings (see point 3 of diagram).
4. Fit the battery compartment into the remote control. Make sure
the + and - markings and the function buttons of the remote control
all point upwards (see right-hand diagrams)!
5. Replace the screw and fasten the battery compartment.
Notes about batteries:
• Keep batteries out of reach of children.
• Do not mix old and new batteries, or batteries of different types. Follow
manufacturer's instructions on battery use.
• Remove old, weak or worn-out batteries promptly.
• Always recycle or dispose of used batteries in accordance with local
regulations.
4. Troubleshooting
The system is correctly connected but the LED on the front of the
subwoofer does not light when switching on.
Make sure you have turned the control at the bottom of the subwoofer
to ON.
No sound
Check you have correctly connected the system to your sound source
and that you have selected the correct sound source. Use the "Source"
button on the remote control to switch between the connected sound
sources (Input 1 and 2) (see Functions section).
5. Technical data
Model no.: SL-8251
Output (RMS)
Frequency range
Impedance
S/N ratio
Dimensions (WxHxD)
Power supply
subwoofer
65 W, 8"
40-150 Hz
8 Ohm
83 dB
248x525x248 mm
12
satellites
2x15 W, 4x1"
150 Hz-20 kHz
8 Ohm
81 dB
100x335x100 mm
230 V
D
GB
F
E
I