Ryobi GD125 Manual Del Operador página 26

Idiomas disponibles

Idiomas disponibles

POSITIONING THE RF ANTENNA
See Figure 39.
 Carefully move the antenna so it hangs below the opener.
NOTE: If the RF antenna is not positioned below the
opener, the signal reception between the opener and the
car remotes may be weakened.
ATTACHING THE EMERGENCY RELEASE
ROPE
See Figure 40.
WARNING:
Do not engage the emergency release while the garage
door is open, do not use the emergency release rope
to raise or lower the garage door, and only engage the
emergency release when the door way is clear of all
people, pets, and obstructions. Failure to properly engage
the emergency release can result in death or serious
personal injury resulting from a falling garage door.
 Locate the following item:
Emergency Release Rope
RF Antenna
Outer
Trolley
INSTALLATION
 Lower the garage door completely.
 Insert one end of the emergency release rope through the
 Insert the other end of the emergency release rope
INSTALLING THE DOOR BRACKET
See Figures 41 - 44.
 Locate the following items:
To install the bracket on sectional garage doors:
 Lower the garage door completely.
 Using a pencil and a level, draw a vertical line in the center
 Center the bracket on the line and place it just below the
Fig. 39
Emergency
Release Rope
Fig. 40
26 - English
hole in the handle and tie a knot at the bottom.
through the hole in the trolley release lever. Pull the rope
up until it is approximately six feet above the garage floor,
then tie a knot.
Door Bracket
Self-tapping Screws (2)
NOTICE:
Before installing the door bracket, ensure that your door
has proper horizontal and vertical support. Aluminum,
fiberglass, and other lightweight garage doors may require
vertical or horizontal reinforcement. Check with your
garage door manufacturer or installer for reinforcement
instructions. Installing a garage door opener on a door
that is not properly supported could damage the door
and void the door warranty.
of the top portion of the garage door.
top of the door or at the same approximate height as the
top roller.
Sectional
Door
Center
Line
Door
Bracket
Screws
Fig. 41

Capítulos

loading

Productos relacionados para Ryobi GD125