TFA Dostmann LOGO Manual De Instrucciones página 29

POSITIONING THE OUTDOOR TEMPERATURE TRANSMITTER:
The sensor is supplied with a holder that may be attached to
a wall with the two screws supplied.
The transmitter can also be position on a flat surface by
securing the stand to the bottom of the transmitter.
.
To wall mount:
1. Mark the wall using a pen through the holes in the holder to obtain the
exact drilling position.
2. Drill holes in the wall at the points marked.
3. Screw holder onto wall.
Note:
Before permanently fixing the transmitter wall base, place all units in the desired
locations to check that the outdoor readings are receivable. In event that the
signal is not received, relocate the transmitter(s) or move them slightly as this
may help the signal reception.
28