Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Precautions when installing speakers below the plasma
display
Place the plasma display as shown in the figure.
See the installation instructions provided with your speak-
ers for instructions on how to install them.
Note
Spread a sheet or similar material so that the display will not
be scratched or damaged.
Always install it on top of a stable table or similar surface.
4
Attach plasma display to support legs.
Fit the stand's support legs into the slots in the center of the
bottom of the plasma display then slowly insert them directly
into the slots. Be extremely careful not to insert the support
legs of the stand into any part of the plasma display other than
the stand insertion slots. Note that doing so might damage
the plasma display panel or its ports or result in the warping of
the stand.
If the plasma display is fitted with handles, it is usually best to
hold the display by its handles when attaching it to the
support legs.
Be sure to work with at least one other person
when attaching the display.
Be careful not to allow your fingers get caught
Caution
between the display and support legs.
If the PDP bracket has been placed into the upper
bracket holes and speakers are to be installed
below the plasma display, care must be taken to
ensure that the display is firmly supported as its
position will be higher.
5
Top side of the
plasma display
6
Line up the support legs
with the bottom of the
plasma display as
indicated in the accompa-
nying diagram.
Installation and assembly instructions
Use the long hexagonal bolts to fix the plasma
display to the support legs (4 locations).
If speakers are to be installed at the sides of the plasma
display, they should be attached at this phase.
See the installation instructions provided with your speak-
ers for instructions on how to install them.
Attach left and right glass stays to support column.
1 Insert the glass stays into the holes provided, pushing
them all the way into the holes so that they point slightly
downwards.
2 Press down on the tips of the glass stays to lower them
and fit the indentations into pins.
Pin
Glass stay
1
1
2
2
Glass stays may be inserted into the upper, middle, or lower
holes to adjust the height of the glass panel. (The middle
holes are designed to be used for standard installation.)
Glass stay (left)
Glass stay
(right)
Long hexagonal bolts
(M8 x 35 mm)
Indentation
Pin
2
1
Side with the
rubber guard is
the upper side.
Upper
holes
Middle
holes
Lower
holes
13
En
Capítulos
Tabla de contenido
