Vega VEGAPULS WL S 61 Manual De Instrucciones página 32

8 Diagnosis, asset management and service
Code Reason
Text message
•
F017 Adjustment
not within
Adjustment span
specification
too small
•
F025 Index markers
are not conti-
Error in the line-
nuously rising,
arization table
for example
illogical value
pairs
•
F040 Hardware
defect
Error in the elec-
tronics
•
F080 General soft-
ware error
•
F105 The instrument
is still in the
Determine mea-
start phase,
sured value
the measured
value could
not yet be
determined
•
F113 EMC interfe-
rence
Communication
error
•
F125 Temperature
of the elect-
Impermissible
ronics in the
electronics tem-
non-specified
perature
range
•
F260 Error in the
calibration
Error in the cali-
carried out in
bration
the factory
•
Error in the
EEPROM
32
Removal Code
Text message
•
Change F261
adjustment
Error in the con-
according to
figuration
the limit values
(difference
between min.
and max.
≥ 10 mm)
•
Check lineari- F264
zation table
Installation/Se-
•
Delete table/
tup error
Create new
•
Exchanging
the electronics
•
Send instru-
ment for repair F265
•
Measurement
Disconnect
function distur-
operating vol-
bed
tage briefly
•
Wait for the
end of the
switch-on
Function check
phase
•
The following table shows the error codes and
Duration
depending on
text messages in the status message "Function
the version
check" and provides information on causes as
and parameter
well as corrective measures.
adjustment up
to approxi-
Code
mately 3 min.
Text message
•
Remove EMC
C700
influences
Simulation ac-
tive
•
Check ambient
temperature
Out of specification
The following table shows the error codes and
text messages in the status message "Out of
•
Exchanging
specification" and provides information on cau-
the electronics
•
ses as well as corrective measures. Send instru-
ment for repair
Code
Text message
S600
Impermissible
electronics tem-
perature
Reason Removal
• •
Error during Repeat setup
•
setup Repeat reset
•
False signal
suppression
faulty
•
Error when
carrying out a
reset
• •
Adjustment Check or
not within the correct ins-
vessel height/ tallation and/
measuring or parameter
range adjustment
• •
Max. measu- Use an instru-
ring range of ment with big-
the instrument ger measuring
not sufficient range
• •
Sensor no Check opera-
longer carries ting voltage
•
out a measure- Carry out a
ment reset
• •
Operating vol- Disconnect
tage too low operating vol-
tage briefly
Reason Removal
• •
A simulation is Finish simu-
active lation
•
Wait for the
automatic end
after 60 mins.
Reason Removal
• •
Temperature Check ambient
of the elect- temperature
ronics in the
non-specified
range
VEGAPULS WL S 61 • 4 ... 20 mA