Direct Mode Measurement; Notes For Accurate Measurement - AND UT-201BLE-A Manual De Instrucciones

Direct Mode Measurement

8. When the direct mode
measurement starts, the mark
blinks. Keep the sensor position
for approximately five minutes.
9. The result is displayed for
approximately one minute, the
direct mode measurement mark
lights, the LED of the
blinks and buzzer sounds when
the direct mode measurement
finishes.
10. Press and hold the
turn the device off.

Notes for Accurate Measurement

The mark lights when the data is stored in memory.
The direct mode measurement is performed after the adjusted mode
measurement is finished.
The device is provided with an automatic power shut-off function with the
buzzer that the device is turned off at approximately one minute later from
removing it or displaying data.
The device can be turned off when pressing and holding the
In measurement, breathe with using nose and closing mouth.
Should the device detect a condition that is abnormal, it will stop the
measurement and display an error symbol. See page 6 for the description of
the symbols.
This thermometer is intended for use by adults only. Consult with your
physician before using this device on a child. A child should not use this
device unattended.
To ensure accurate measurement, wait at least 30 seconds between each
use to allow the thermometer to return to room temperature.
Measurements
Count down indicator
switch
switch to
English 14
Measurement start
Direct mode
measurement mark
The result
Mark lights
Turn off the device.
From last page
switch.