Tabla de contenido
Advice in the event of a fault
10. Advice in the event of a fault
Maintenance and care
Should the LC display indicate meaningless infor-
mation or should the flash unit not work properly
In caso di anomalie di funzionamento
in the individual modes, then switch off the flash
Cura e manutenzione
unit for about 10 seconds by its main switch.
Ayuda en caso de problemas
Check the camera settings and find out if the flash
Mantenimiento y cuidados
unit's foot is correctly mounted in the camera's
accessory shoe.
The flash unit must operate properly when it is
switched on again. Contact your local dealer
should this not be the case.
11. Maintenance and care
Remove any grime and dust with a soft, dry or
silicon-treated cloth. Never use detergents that
could damage plastic parts.
Forming the flash capacitor
The flash capacitor incorporated in the flash unit
undergoes a physical change when the flash unit
is not switched on for prolonged periods of time.
For this reason it is necessary to switch on the
mecablitz for approx. 10 minutes every 3 months
(see 2.4!). The batteries must supply sufficient
power for flash readiness to be indicated within 1
minute after the mecablitz was switched on.
64
Tabla de contenido
