Tabla de contenido
Idiomas disponibles
Idiomas disponibles
support of the saw.
Fig. 4
A typical illustration of proper hand support,
workpiece support, and supply cord routing.
000161
16. Place the wider portion of the saw base on
that part of the workpiece which is solidly
supported, not on the section that will fall off
when the cut is made. As examples, Fig. 5
illustrates the RIGHT way to cut off the end of
a board, and Fig. 6 the WRONG way. If the
workpiece is short or small, clamp it down. DO
NOT TRY TO HOLD SHORT PIECES BY HAND!
Fig. 5
000163
Fig. 6
000165
17. Never attempt to saw with the circular saw
held upside down in a vise. This is extremely
dangerous and can lead to serious accidents.
Fig. 7
000152
18. WARNING: Blade coasts to stop after switch is
released. Contact with coasting blade can
cause serious injury. Before setting the tool
down after completing a cut, be sure that the
lower (telescoping) guard has closed and the
blade has come to a complete stop.
19. Some material contains chemicals which may
be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
SAVE THESE INSTRUCTIONS.
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
Symbols
The followings show the symbols used for tool.
･
volts
･
amperes
･
hertz
･
alternating current
･
no load speed
･
revolutions or reciprocation per minute
FUNCTIONAL DESCRIPTION
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before adjusting or checking function on
the tool.
6
USD101-2
Tabla de contenido
