Kreg KMS7520 Manual Del Propietário

WARNING:
This product can expose you to chemicals including Carbon 1333-86-4,
which are known to the State of California to cause cancer. For more information go to
www.P65Warnings.ca.gov.
• Kreg Track Clamps are intended for use with the Kreg Accu-Cut™ family of products, Kreg Adaptive
Cutting System Guide Track, Kreg Combo-Trak, and Kreg Mini Trak.
• Read, understand, and follow the safety warnings and operation instructions included with this product,
and any other Kreg product(s) used in combination with his product, and those provided by your electric
tool manufacturer. Keep all guards and safety devices in place.
• Wear proper eye, ear, and respiratory protection.
Position one Track Clamp in the starter-block recess nearest the edge
of the track used for cutting.
Position one Track Clamp in the T-slot on the underside of the Guide
Track near the outfeed end.
Track Clamp
ITEM# KMS7520
Article #KMS7520
Artículo # KMS7520
Position a second Track Clamp in the track T-slot along the
same edge at the opposite end of the track.
Kreg
Position a second Track Clamp in the same T-slot at the infeed
Other Kreg Trak Products
®
Keep heel on track
www.kregtool.com • 800.447.8638
WARNING
always follow the safety precautions below to reduce the risk of fire, electric shock,
and personal injury. Read all these instructions before attempting to use this product.
SAVE THESE INSTRUCTIONS.
• Always disconnect your electric tool from power before making adjustments to the tool or Track Clamps.
• Allow the electric tool to come to a complete stop before making adjustments or removing the workpiece.
• Maintain your tools and accessories. Check for misalignment or binding of moving parts, loose
fasteners, broken parts, and any other condition that may affect safe operation. If an unsafe condition
is discovered, correct it before use.
Kreg Accu-Cut Products
® ™
Adaptive Cutting System
®
(Cord Manager) end of the Guide Track.
A Shop-Made Jig or Fixture
Drill Hole
ø
⁄
1
Owner's Manual
Guide d'utilisation
Manual del propietario
When using this accessory with electric tools or another Kreg product,
Use Track Clamps to secure Accu-Cut™ tracks when cutting
materials with a slippery surface, when cutting a workpiece that is
not flat, and when cutting using only one track section.
Use Track Clamps to secure the Adaptive Cutting System Guide
Track when cutting materials with a slippery surface,
or cutting a workpiece that is not flat.
Counterbore
ø " [ 16 mm ]
⁄
5
8
" [ 6.5 mm ]
4
NK9020
Version 2 - 2/2019