Engine; Transmission; Centrifugal Clutch; Wheel Assemblies - RIDGID K-1000 Manual Del Usuario

5. Repeat step 9 above until 50 lbs. (22 kg) reading is
obtained.

Engine

Always check engine oil level. For complete directions
on engine maintenance, consult the Engine manual en-
closed.

Transmission

The transmission needs no relubrication, however, a leak
in a seal could allow grease to be depleted after several
hours. Such a leak will be obvious and should be cor-
rected.

Centrifugal Clutch

Centrifugal clutch will automatically engage when the
throttle is opened. No maintenance should be necessary.
However, if slippage should occur from dirt or grease en-
tering clutch, the foreign material should be removed.

Wheel Assemblies

All four wheel assemblies should be greased once a year.
The grease fitting is located on the inside face of the
hub.

Checking Engine Idle (RPM) Speed

After engine has started, squeeze throttle handle to rev
engine at high speed and immediately release so that
engine returns to idle.
At idle speed the drive shaft should not
WARNING
be turning. If drive shaft does turn, make sure that Throt-
tle Control Spring is connected or adjust idle speed at
the throttle cable handle by loosening stop nut and ad-
justing cable length (Figure 1).

Throttle Adjustment

Throttle control is factory set and should not require ad-
justment. If idle speed seems too high or engine does
not speed up when throttle is pulled check throttle link-
age.
1. Check speed adjustment by adjusting cable posi-
tion; loosen clamp at bracket and move slightly.
2. For idle adjustment and mixture control, refer to
engine manual enclosed.
K-1000 Rodder

"V" Belt Tension Adjustment

"V" Belt should be checked at least once a month. Belt
tension should be just enough to drive maximum load
at high speed with throttle open. Excess belt tension will
cause the centrifugal clutch to creep at idle speed. "V"
Belt is tightened by loosening engine mounting bolts
and sliding engine to rear.

Main Bearings

The Main Bearings should be greased after using ma-
chine on 12 jobs or once every three months, whichever
comes first. Guard must be removed to grease front
main bearing. Chain should be checked and greased
while guard is removed.
Do not use machine with guard re-
WARNING
moved.

Storing of Rods

Rods should be thoroughly flushed with water to pre-
vent damaging effect of some drain cleaning com-
pounds. Periodically, lubricate rods and couplings with
oil. When storing, uncouple rods. Do not store in a coil
since this could cause bending and damage.

Tool Storage

Motor-driven equipment must be in-
WARNING
doors or well covered in rainy weather. Store the ma-
chine in a locked area that is out of reach of children and
people unfamiliar with machine. This machine can cause
serious injury in the hands of untrained users.
11