Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION INSTRUCTIONS
Lubrication
This compressor is shipped with oil.
Remove cap from oil fill opening. Install breather (found in parts bag
with this manual). See Figure 2. Check oil level. See specification
label on compressor pump for the proper oil capacity and oil type.
Do not use regular automotive oil. Additives in regular motor oil can
cause valve deposits and reduce pump life. For maximum pump life,
drain and replace oil after the first hour of run time.
This pump has an oil sight glass as shown in Figure 2. Oil level can
be monitored and maintained as shown in Figure 2.
Refer to engine manual for proper oil level and type.
Before operating compressor, fill to the center of
the sight gauge (see Figure 2).
Using any other type of oil may
shorten pump life and damage valves.
Recommended Oil (2 Options)
FSC-1000A ISO-100 Premium Reciprocating
Compressor Lubricant
12 quart case part number FSC-1000A-12
1 quart part number FSC-1000A-1
For generic option use 10W30
Oil Capacity
Approximately 8.5 oz.
Fill the pump with oil to the center of the sight gauge using oil fill
opening (see Figure 2).
Do NOT fill the pump through the breather cap
opening as this may cause oil to leak and spray out during operation.
NOTE: Some residual oil may still be in the pump from factory
testing leaving a thin coat on the sight gauge; however, there is not
enough oil to operate the unit.
Oil Drain Plug
Sight Gauge
Figure 2 - Lubrication
7
Oil Fill Plug
Full
Low
Tabla de contenido
