Marvel MP15CPG2 Serie Instrucciones De Instalación, Operación Y Mantenimiento página 18

Cabinet
"Z" Bracket
Figure 27
"P" clamp
and screw
Bottom of
Figure 27b
door
Press and hold down this
tab on the wire connector
and pull the connector apart.
Figure 28
Step 2: Remove the door gasket
With the door laying on a flat surface and starting at a cor-
ner of the door remove the magnetic door gasket from it's
retainer by pulling it away from the interior side of the door,
see Figure 29. Set the gasket aside on a flat surface.
There are 10 holes in the gasket retainer extrusions, (3 on
each side and 2 at the top and bottom which are used to
fasten the panel to the front of the door. The screws are
provided in the literature pack.
OVERLAY DOOR PANEL INSTALLATION
Loosen (do not remove ) these
2 phillips head screws on the
top and bottom hinges
Figure 27a
Wire connector
see Figure 28
Holes in
gasket
retainer.
Figure 29a
Figure 29
CAUTION
!
Weight of overlay door panel must not exceed 15
pounds (6.8 kg).
Step 3: Cut and drill the overlay panel
Depending on your model cut the overlay door panel to the
dimensions shown in Figure 30 to Figure 33.
18
Overlay panel
flush with top
of door.
Overlay panel to
be centered on
width of door.
Magnetic Gasket
remove starting at a
corner, grasp and pull
away from the door.