Marvel MP15CPG2 Serie Instrucciones De Instalación, Operación Y Mantenimiento página 16

3
1
2
Figure 22
Remove all of
the ice from
the ice bin
Figure 24
CLEANING YOUR ICE MACHINE
Remove the grid
cutter cover
Figure 23
Remove the
reservoir drain
plug from the
bottom of the
reservoir.
Figure 24a
Refer to your cleaning solution instructions to determine
the proper amount of cleaning solution to add based on 2
quarts (1.9 liters) of water. Remove the plastic splash shield
to improve access. (See Figure 25). Pour the cleaning solu-
tion slowly on the evaporator plate so it flows down into the
fresh water reservoir. (See Figure 26).
Splash shield
brackets
Replace the splash shield if removed.
Turn the ice machine back on by pressing and
holding the "ON/OFF" icon for 3 seconds. The
display will indicate "ICE" mode. Press and hold the
"MENU" icon until a flashing "CLEAN" is dis-
played. Press the "ON/OFF" icon until "CLEAN"
stops flashing. Your ice machine will now enter
the clean cycle.
The clean and rinse cycle will take about 49 min-
utes.
After the clean cycle is complete the ice machine
will return to the "OFF" position.
After the cleaning cycle is completed, verify that all build-up
has been removed. If not repeat the clean cycle procedure.
Evaporator
plate
Grid cutter
16
Splash shield
Figure 25
Pour cleaning solution slowly
onto front edge of evaporator
plate behind the grid cutter.
Figure 26
ICE
CLEAN
OFF