General Advices - Skyfood DAL-06 Manual De Instrucciones

PROBLEM
Electric energy shortage
The machine does not start
Problem with the internal or
external wiring
Problem with the internal or
Burnt smell or smoke
external wiring
The machine starts, but when Belts sliding
the product is placedon the
Disc, the disc stops ot turns Problems with the Electric
slowly Motor
The abrasive disc is not correctly
placed
Abnormal noises
Problems with the bearings
Water leaks through the
The retainer is damaged
bu on

6. General Advices

- Do not wear loose fi ng clothes while opera ng the unit. Do not use bracelets or any
other piece of jewelry. Have your hair always shortened and held up (use hair fishnets if
necessary) in a way it cannot reach any part of the machine. Roll up any loose sleeves.
- SKYFOOD is not responsible for any harm or injury caused by the negligent or inappropriate
use of this equipment by any operator. This equipment must be operated only by persons
whose age equals or exceeds 18 years old, in a safe and sound state of mind, free from the
influence of any kind of drugs and alcohol, that received proper training and instruc ons
regarding the correct opera on of this machine, that are wearing correct and authorized
safety clothes. All and any kind of modifica ons carried on and applied to this machine
immediately nullifies any kind of warranty and may result in harm and injuries to the
individuals opera ng this machine and to individuals that are located in the machine
surrounding areas while it is being operated.
- Under no circunstances place your hands in the moving parts of the machine while it
is being used. Make sure the machine has come to a complete stop before acessing the
processed ingredients.
12
TABLE 02
CAUSES SOLUTIONS
Check Electric energy source
Call Technical Asistance
Call Technical Asistance
Call Technical Asistance
Call Technical Asistance
Place correctly the Abrasive
Disc
Call Technical Asistance
Call Technical Asistance
PROBLEMAS
Falta de energia eléctrica en la
red
La maquina no prende
Problema en el circuito eléctrico
interno o externo de la maquina
Problema en el circuito eléctrico
Olor a quemado ó humo
interno o externo de la maquina
La maquina prende, sin
enbargo cuando el producto Correa desliza
es colocado sobre el disco,
este para o gira en baja Problema con el motor eléctrico
rotación
Disco abrasivo en mala posición
Ruidos anormales Rodamientos dañados
Retentor dañado
TABLA 02
CAUSAS SOLUCIONES
Verifique si hay energia
eléctrica en la red
Llame la Asistencia Técnica
Llame la Asistencia Técnica
Llame la Asistencia Técnica
Llame la Asistencia Técnica
Coloque correctamente el
disco abrasivo
Llame la Asistencia Técnica
Llame la Asistencia Técnica
25