Insert The Batteries - TFA Dostmann 30.3065.02 Instrucciones De Uso

TFA_No. 30.3065_Anl_08_19
Wireless thermometer
5.2 Transmitter (Fig. 3+4):
D 1: LED signal lamp
D 2: Battery compartment
D 3: Mounting hole
6. Getting started

6.1 Insert the batteries

• Place the instruments on a table at a distance of about 1.5
meters from each other. Avoid being close to possible
sources of interference such as electronic devices and radio
equipment.
• Open the battery compartment of the transmitter and insert
a new battery (1,5 V AA), ensure that battery polarities are
correct. The LED signal lamp flashes.
• Close the battery compartment again.
• Remove the protective film from the base station display.
• Open the battery compartment of the base station.
• Insert a new battery (1,5 V AA), polarity as indicated. All
segments will be displayed briefly. The indoor temperature
and humidity appear on the display.
• Close the battery compartment again.
24
20.08.2019 19:50 Uhr Seite 13
Wireless thermometer
6.2 Reception of outdoor transmitter
• After inserting the batteries the transmitter will automatical-
ly transmit the temperature. The reception symbol will be
flashing on the display.
• If the reception of outdoor temperature fails, "- -" appears
on the display. Check the battery and try it again. Check if
there is any source of interference.
• You can also start the initialization manually. Hold the
°C / °F and HI / LOW button on the base station for five se-
conds at the same time.
• "- -" appears on the outdoor temperature display and the
reception symbol flashes. The base station will scan again
the outdoor temperature.
7. Operation
7.1 Indication of the temperature
• Press the °C / °F button to change between °C (Celsius) or
°F (Fahrenheit) as temperature unit.
7.2 Maximum and minimum values
• There are two memory modes for highest and lowest values.
25