Tabla de contenido
TFA_No_30.3033_Anl_8_spr_10_12
MIAMI
– Wireless pool thermometer
•
Unauthorised repairs, modifications or changes to the product are prohibited.
•
The product is not be used for medical purpose or for public information, but is
intended only for home use.
Caution!
Risk of injury:
•
Keep these instruments and the batteries out of reach of children.
•
Batteries must not be thrown into the fire, short-circuited, taken apart or recharged.
Risk of explosion!
•
Remove the batteries if you do not use the products for a lengthy period.
•
Batteries contain harmful acids. Low batteries should be changed as soon as possible
to prevent damage caused by a leaking battery. Never use a combination of old and
new batteries together, nor batteries of different types. Wear chemical-resistant pro-
tective gloves and glasses when handling leaked batteries.
Important information on product safety!
•
Do not place the unit near extreme temperatures, vibration or shock.
•
Protect the basic unit from moisture.
5. Elements
5.1 Receiver (Basic unit) Fig. 1
LCD
A1:
Channel number
A2:
Water temperature
A3:
Time
A4:
Battery indicator transmitter
A5:
Trend indicator water temperature
A6:
Indoor temperature
Buttons
B1:
"▲ (12/24)" button
B2:
"SET/MODE" button
B3:
"SEARCH/CH" button
B4:
"▼ ALARM ON/OFF" button
B5:
"ALERT" button
14
24.10.2012
11:51 Uhr
Seite 8
MIAMI
– Wireless pool thermometer
B6:
"MAX/MIN" button
B7:
"RESET" button
Housing
C1:
Wall Mount Hole
C2:
Battery Compartment
C3:
Stand (removable)
5.2. Pool sensor (transmitter) Fig. 2
D1:
"TX" button
D2:
"°C/°F" button
D3:
Transmission indication LED
D4:
Water temperature
D5:
Water temperature sensor
D6:
For fastening rope
D7:
Screws battery compartment
6. Getting started
6.1 Insert battery
•
Place both instruments on a desk with a distance of approximately 1.5 meter. Check
that no other electronic devices are close.
•
Press and hold "TX" button and "°C/°F" button at the same time for 3 seconds to
switch on the transmitter. The current temperature and channel 1 are shown on the
LCD.
•
Insert the attached batteries (3 x 1.5 V AA) into the battery compartment of the dis-
play unit, observing the correct polarity.
6.2 Reception of pool sensor
•
The basic unit automatically starts scanning the 433 MHz signal to register the thermo
sensor unit after batteries are inserted. If the reception of outdoor values fails, "- -"
appears on the display. Check the batteries and try it again. Check if there is any source
of interference.
•
Manual initialization can be helpful. Hold "SEARCH/CH" button on the basic unit for
3 seconds. The registered transmitter (channel) is canceled.
•
Press "TX" button on the transmitter. The basic unit gives a "beep" sound if it received
the temperature.
7. How to operate
•
Important: Buttons will not function while scanning the outdoor temperature signal.
•
During operation, all successful settings will be confirmed by an acoustical signal.
15
Tabla de contenido
