Use; Warning Displays - Balance KH 5522 Instrucciones De Manejo

• Place your glass scale on a flat, solid surface.
Please ensure that both the floor where the
weigh scales are set up and the surface of the
weigh scales are not wet to ensure that
nobody slips.
Please note!
The glass scale contains sensitive electronic compo-
nents and must therefore not be installed
• close to heat sources
• in environments that are exposed to extreme
humidity

Use

Attention: Never burden the scales one-sidedly. Al-
ways step onto the scales in the middle and with
both feet. If you do not, the digital glass scale could
tip to one side and be irreparably damaged.
Additionally, there is the risk of falling over!
1. Tap your foot lightly on the centre of the scale
until "HI" appears on the LCD display.
2. Stand with both feet on the scale once "0.0"
appears on the LCD display. Stand calmly and
without shifting your weight.
3. During weighing, the "kg/lb" LCD display flas-
hes and the displayed value rises until your
weight has been determined.
4. The "kg/lb" display now stops flashing and your
weight is displayed in grades of 0.1 kg/0.2 lb.
Attention: never jump on to the scale as this may
cause damage.

Warning Displays

"0_Ld" appears in the LCD display if the weight ex-
ceeds the maximum weighing capacity of 180
kg/396 lb. Step off the scale immediately as you
may otherwise cause damage.
Replace the batteries if "Lo" appears in the display.
The scale is unable to measure the weight if "Err"
appears in the display. Step off the scale in this
case, wait for a few seconds and then try again.
Make sure you stand calmly and do not interrupt
the weighing process.
- 22 -