EGAmaster 56885 Manual De Instrucciones página 23

Applies to 1, 1.5, 2, 2.5 gallon reservoirs:
Remove the five allen socket head cap screws, securing the screen to the 1st stage gear
pump. Care should be taken not to remove the center plate and gears. Remove and clean with
nonflammable solvent, blow dry clean. Reinstall in reverse order and torque bolts to 75 inch
pounds. Keep the motor and pump as clean as possible.
Applies to the 5 and 10 gallon reservoirs:
Unscrew screen from bottom of pump unit and clean with nonflammable solvent. Blow dry
and reassemble.
Keep areas around pump unobstructed to provide good air flow around the motor and pump.
Keep the motor and pump as clean as possible.
Run the pump in no load condition for 1 or 2 minutes maximum. Unplug the pump and
remove the motor and pump assembly again. Now drain the flushing oil and re-clean the inside
of the reservoir. (Make sure flushing fluid is also drained from pump assembly). Reassemble the
pump and refill the reservoir with the manufacturer hydraulic oil and reassemble the pump.
23