EGAmaster 56885 Manual De Instrucciones página 17

recommended safety precautions to avoid personal injury or damage to the unit. The
manufacturer cannot be responsible for any damage or injury from unsafe use, lack of
maintenance or incorrect operation. In the event any questions or concerns arise, contact the
manufacturer or a local representative for clarification.
The pump's maximum working pressure is 10,000 PSI(700kg/cm2). Make sure that all
hydraulic equipment such as rams, hoses, etc. used with this pump are rated at 10,000 PSI
(700kg/cm2) operating pressure.
If you have never been trained on high-pressure hydraulic safety, consult your representative.
Failure to comply with the following cautions and warnings could cause equipment damage,
property damage or personal injury.
DANGER is only used when your action or lack of action may cause serious injury or even
death.
WARNING indicates a potential danger that requires correct procedures or practices to avoid
personal injury.
CAUTION is used to indicate correct operating or maintenance procedures and practices to
prevent damage to, or destruction of equipment, or other property.
WARNING: Wear proper personal protective gear when operating hydraulic equipment.
DANGER: To avoid personal injury, keep hands and feet away from work-piece during
operation.
WARNING: Do not exceed equipment ratings. Overloading causes equipment failure and
possible personal injury. The pump tools are designed for a maximum pressure of 10,000
PSI (700kg/cm2). Do not connect a jack or cylinder to a pump. Never set the relief valve to a
higher pressure than the maximum rated pressure of the pump. Higher settings may result in
equipment damage and/or personal injury.
WARNING: The system operating pressure must not exceed the pressure rating of the lowest
rated component in the system. Install pressure gauges in the system to monitor operating
pressure.
CAUTION: Avoid damaging hydraulic hose. Avoid sharp bends and kinks when routing
hydraulic hoses. Using a bent or kinked hose will cause severe back-pressure. Sharp bends
and kinks will internally damage the hose, leading to premature hose failure. Do not drop heavy
objects on hose. A sharp impact may cause internal damage to hose wire strands. Applying
pressure to a damaged hose may cause it to rupture.
IMPORTANT: Do not lift hydraulic equipment by the hose or swivel couplers. Use the carrying
handle or other means of safe transport.
CAUTION: Keep hydraulic equipment away from flames and heat. Excessive heat will soften
seals, resulting in fluid leaks. Heat also weakens hose materials. For optimum performance do
not expose equipment to temperatures of 65° C (170° F) or higher. Protect hoses and cylinders
from weld spatter.
SAFE AND CORRECT USE
17