EGAmaster 56885 Manual De Instrucciones página 19

Use only tools, hoses and accessories rated at 10,000 PSI (700kg/cm
shipping plugs from the ports to connect your coupling(s) or hose(s) to manifold. Use 1.5 wraps
of Teflon tape (or suitable thread sealant) on all threads, leaving the first complete thread free of
tape to ensure no foreign matter enters the hydraulic circuit.
When making connections with quick disconnect couplings, make sure the couplings are fully
engaged. Threaded connections such as fittings, gauges, etc. must be securely tightened and
leak free.
WARNING
Loose or improperly threaded fittings can be potentially dangerous if pressurized; however,
severe over tightening can cause premature thread failure. Fittings need to be tightened
secure & leak free. Never hold or stand directly in line with any hydraulic connections while
pressurizing. Never grab, touch or in any way come in contact with a hydraulic pressure leak.
Escaping oil can penetrate the skin and a serious injury can result.
CAUTION: Do not subject the hose to potential hazards such as sharp surfaces, extreme
heat or heavy impact. Do not allow the hose to kink or twist. Inspect each hose for wear before it
is used.
ELECTRICAL
Check for proper electrical supply before connecting. Be sure the electrical connection
is grounded. Check that your power supply agrees with the motor nameplate and/or the
manufacturer model decal.
NOTE: MOTOR MAY SPARK. DO NOT OPERATE IN AN EXPLOSIVE ATMOSPHERE OR
IN THE PRESENCE OF CONDUCTIVE LIQUIDS.
1. Do not use a power or extension cord that is damaged or has exposed wires.
2. All single phase motors come equipped with a three prong grounding type plug to fit the
proper grounded type electrical outlet. Do not use a two prong ungrounded extension cord as
the pump's motor must be grounded.
INSTALL HYDRAULIC CONNECTIONS
TECHNICAL SPECIFICATIONS
2
). Remove the
19