Operating Instructions - SKF THKI 300 Instrucciones De Uso

3. Operating instructions

A. Handle
B. Oil injector
C. Release valve
D. Pressure gauge
Preparations before use
• Read the safety recommendations before
starting any work
• Inspect all components for damage.
Pay particular attention to high pressure pipes.
Damaged high pressure pipes must not be used
and should be discarded
• For mounting operations it is recommended
to use oil with a viscosity of approximately
300 mm /s (1 400 SUS) at the operating
2
temperature.
For dismounting operations, its is recommended
to use oil with a viscosity of approximately
900 mm /s (4 100 SUS) at the operating
2
temperature.
• Use only clean oil. Dirty oil can permanently
damage the internal workings of the unit
(† see 4.4).
• Fill the oil reservoir. Immerse the end in a
container of clean oil. Pull the handle to suck
the oil into the reservoir.
A
H
G
E. Gauge nipple
F. High pressure pipe (not shown)
G. Oil reservoir
H. Stand
• Turn the reservoir upside-down and push on
the ball to remove any air from the reservoir.
D
C
E
B
EN 5