Idiomas disponibles
Idiomas disponibles
„Next>".
4. The setup status screen shows. This advises
current operation status with a progress bar.
This may take a few minutes.
5. The „Completed the Photomizer Setup Wiz-
ard" screen shows. Click here on „Finish".
MikrOkular driver installation
During Photomizer SE software installation the
correct driver for your operating system will
be installed automatically. No manual input is
needed.
In rare cases the device may not be recognised
by your computer. As a rule you need then only
install the driver manually from the CD. If this
fails please refer to the troubleshooting chapter
that follows.
Troubleshooting: the device isn't recognised
by the computer (USB)
1. This occurs in rare cases whith some OEM
Windows Vista or XP versions. The device is
not defective. Updating the notebook or PC
USB driver usually suffices.
2. If not, proceed as below. (The maker can-
not accept any liability whatsoever in these
cases
).
1
Delete ghost devices. These are devices not
actually currently connected to your computer.
The reason for this is that Windows generates
a system settings entry for each USB device (
e.g USB Stick) on each port. It then seeks that/
those device/s each time it's started. This
slows down USB device recognition and Win-
dows booting and causes non-recognition of
USB ports.
Cleaning up the system environment and delet-
ing devices that are no longer in use helps here.
To do so right click WORKPLACE (COMPUTER
in Vista) and open the PROPERTIES menu. Then
click the ADVANCED tab as in illustration 6 (AD-
VANCED SYSTEM SETTINGS in Vista) and then
ENVIRONMENT VARIABLES. Choose the NEW
option in ENVIRONMENT VARIABLES as in illus-
tration 7. Enter the following under VARIABLE
NAME as in illustration 8.
devmgr_show_nonpresent_devices
Under VARIABLE VALUE enter „1".
Confirm your input with OK and then reboot the
computer.
Change to the device manager. In the VIEW
menu activate the SHOW DEVICES OPTION.
The ghost devices previously not shown will
now be displayed in light grey. Check the vari-
ous categories including USB, memory size,
etc. Only delete entries for devices you no
longer use.
1
Source: Microsoft Knowledge Base
1
http://support.microsoft.com/kb/315539/de
*Not included
**System requirements: Intel X86 processor with at least 2.0 GHz
speed, 200 MB hard disc space, 512 MB RAM memory, Windows
XP or Vista (32-bit) and a free USB port (not via a hub if possible).
Using the MicrOcular
Preparation
1. Slide a specimen under your microscope and
focus on it.
2. Remove the eyepiece and Barlow lens from
the eyepiece support and the dust cap from
your MikrOkular and install same in the eye-
piece supports instead of the Barlow lens.
3. Start your PC if you haven't yet and connect
your MikrOkular to the USB port of your com-
puter.
Showing and saving MikrOkular images on
your PC.
1. Start the Photomizer SE Software.
2. Click „Open camera"
3. If you have more than one device connected
up select the one you want from the choice
offered. Click „SoC PC-Camera" or „MikrOku-
lar". Omit this step if you only have a single
device connected up.
4. The camera image should now be visible on
your screen. Focus the microscope image.
5. Click „Capture" to record an image. It will
then be shown on the right.
6. Click on it to select it and then click „Transfer
image".
7. This takes you to the Photomizer SE soft-
ware.
8. File - Save as
EN
17
