Bosch GTA10W Instrucciones De Funcionamiento Y Seguridad página 5

BM 2610019165 10-11:BM 2610019165 10-11.qxp 10/13/11 7:50 AM Page 5
Locate the four tool mounting holes on the
stand frame. Insert and tighten the four
knobs to the saw on all corners to securely
fasten the saw to the stand (Fig. 10).
FIG. 10
MovINg The SAw
Read
WARNING
instructions identified by
BUlleT (•) symbol listed Below before
moving the saw with the stand or folding
the stand. Failure to follow these instructions
may result in property damage or serious
personal injury.
• Turn tool switch off and unplug power
cord to disconnect tool power.
• empty water from tile saw water tray by
following "Filling and Draning the water
Tray" instructions in Bosch TC10 manual.
• Make sure the work table is locked with
table lock.
• Make sure saw is securely fastened to
stand with the mounting bolts. See
"Mounting Tile Saw" on page 4 & 5 of this
manual.
1. Remove the extension table and invert it
on the work table. Align the hole in the
extension table with the hole in the sliding
work table, pull out the pin attached to the
extension table, and lock the extension
table on the work table by inserting the pin
into the holes (Fig. 11).
FIG. 11
and follow the
-5-
2. Remove the side and rear extension water
trays.
3. Unlock the wheels on the stand.
4. Hold the handle of the stand firmly, lift the
stand, and make sure that the two legs
without wheels are about 1/2 inch above
the ground (Fig.12).
FIG. 12
5. The stand may also be fully or partially
folded, as shown in Fig. 13 and Fig. 14. To
fold the stand, please see "Closing the
Stand" on page 4.
FIG. 13