Agri-Fab 19A-116-OEM Manual De Operador página 6

14. Assemble a seal (turned as shown in figure 5) onto the
motor shaft. Slide it up against the motor.
15. Assemble the impeller coupler onto the motor shaft and
secure it with a 1/8" x 1-1/4" cotter pin. Spread the ends
of the pin around the coupler. See figure 5.
(L) 1/8" x 1-1/4"
COTTER PIN
FIGURE 5
16. Place the screen down into the hopper. DO NOT place
it under the clips in bottom of hopper at this time. See
figure 6.
17. Place the motor assembly down into the hopper, inserting
the end of the spreader shaft into the impeller coupler.
Secure it with a 1/8" x 1-1/4" cotter pin, spreading the
ends of the pin around the coupler. See figure 6.
18. Fasten the motor mount bracket to the hopper using four
5/16" x 1" hex bolts, 5/16" flat washers, nylon washers
and 5/16" nylock nuts. See figure 6.
MOTOR
ASSEMBLY
(F) 5/16"
NYLOCK NUT
(I) 5/16" FLAT
WASHER
(C) 5/16" x 1"
HEX BOLT
(J) NYLON
WASHER
FIGURE 6
19. Lift the screen up and slide the seal down the spreader
20. Slide one edge of the screen under one of the clips.
(P) SEAL
(O) IMPELLER
COUPLER
FIGURE 7
21. Attach the mounting brackets to the hopper tubes using
(L) 1/8" x 1-1/4"
COTTER PIN
SPREADER
SHAFT
SCREEN
(B) 5/16 x 2"
HEX BOLT
FIGURE 8
6
shaft to rest against the plastic bushing in the bottom
of the hopper. See figure 7.
Then, slightly bow the screen to slide the opposite side
of the screen under the other clip. See figure 7.
CLIP
SCREEN
CLIPS
four 5/16 x 2" hex bolts, 5/16" flat washers and 5/16"
nylock nuts. DO NOT TIGHTEN YET. See figure 8.
SHAFT
(O) SEAL
BUSHING
(F) 5/16" NYLOCK NUT
(I) 5/16" FLAT WASHER