Tools Required For Assembly - Agri-Fab 19A-116-OEM Manual De Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

ASSEMBLY INSTRUCTIONS

TOOLS REQUIRED FOR ASSEMBLY

(1) Pliers
(2) 7/16" Wrenches
(2) 1/2" Wrenches
(2) 9/16" Wrenches
CAUTION: PARTS OF TRACTOR
MAY BE HOT! MAKE SURE ENGINE
AND MUFFLER ARE COOL BEFORE
INSTALLING SPREADER!
REMOVAL OF PARTS FROM CARTON
Remove all parts and hardware packages from the carton. Lay
out all parts and hardware and identify using the illustrations
on pages 2 and 3.
INSTALLING THE COUNTER WEIGHT
The counter weight must be installed on the front of the
tractor's foot rest using the two 3/8" x 2-3/4" hex bolts and
3/8" nylock nuts.
Because openings between the foot rest and the tractor frame
(See Figure 1) provide only limited access for installing the
nylock nuts, it is recommended that you enlarge these access
areas by temporarily raising the front of the foot rest
TO RAISE THE FRONT OF THE FOOT REST, PROCEED
AS FOLLOWS:
1. Remove the two hex tapp screws that secure the front
tabs of the foot rest to the front bracket of the tractor
frame.
2. Grasp the front of the foot rest and lift it upward. Use
one (or both) of the following methods to hold the front
of the foot rest in the raised position while installing the
weight. See Figure 1.
-
Lift the front of the foot rest so that the holes in the
mounting tabs are above the frame bracket. Reinsert
the hex tapp screws into the tab holes, and lower the
foot rest until screws are against the front edges of the
frame bracket.
-
Locate a thin board, bar, rod, etc. to use as a wedge. Lift
the front of the foot rest and insert the wedge fully beneath
the foot rest, between the foot rest and frame.
TO INSTALL THE WEIGHT:
3. Insert a hex bolt through the hole at each end of the
weight.
4. Lift the weight w/bolts and align the bolts with the two
holes in the front of the foot rest. Insert the bolts through
the foot rest holes and hold the weight in position on
the front of the foot rest.
5. While continuing to support the weight, hand thread the
two nylock nuts onto the bolts. Use a 9/16" wrench to
secure the nylock nuts and fully tighten the hex bolts.
6. Lift the foot rest/weight and remove the wedge and/or
tapp screws holding the foot rest upward.
7. Align the holes in the foot rest tabs with the holes in the
frame bracket and reinstall the hex tapp screws. Do Not
Over Tighten.
NOTE: The weight assembly can be installed without raising
the foot rest. With the aid of an assistant to hold the weight
assembly in position, use a 9/16" box wrench to carefully
maneuver the nylock nuts into position underneath the
foot rest. If you drop the nut, you may have to remove
the foot rest to retrieve the nut.
FOOT REST
DESCANSO PARA LOS PIES
REPOSE-PIED
ACCESS
AREA
(G) 3/8"
NYLOCK NUT
HEX TAPP SCREW
TORNILLOS HEXAGONALES ROSCADORES
VIS HEXAGONALES
FIGURE 1
4
(A) 3/8" x 2-3/4"
HEX BOLT
WEIGHT
CONTRAPESO
CONTREPOIDS
WEDGE
CUÑA
CALE
Tabla de contenido
loading

Este manual también es adecuado para:

19a-116-100

Tabla de contenido