Cleaning; Decalcification Of The Water Kettle; Troubleshooting - Profi Cook PC-TKS 1056 Instrucciones De Servicio

CAUTION:
• Always turn the device off before cleaning it and remove the mains
plug. Wait until the device has cooled down.
• Do not immerse the water kettle or base into water or other liquids.
CAUTION:
• Do not use any wire brush or other abrasive
objects.
• Do not use any acidic or abrasive detergents.
Water kettle
• Rinse the water container out with clean water.
Then dry it off with a cloth.
• Clean the housing after use with a slightly damp
cloth.
• Clean the perforated surface of the spout open-
ing with a nylon brush from the inside.
Tea/coffee maker / filter
Clean the tea/coffee maker and filter as usual in
soapy water. Rinse with clear water afterwards. Dry
the tea/coffee maker and filter with a cloth.
Winding mechanism for the power cord
You may wind the power cord on the bottom area of
the base station.

Decalcification of the water kettle

• The frequency of the decalcifying operation
depends on the hardness of the water and on
how often the appliance is used.
• If the machine switches off before the water
boils, it probably needs to be decalcified.
• Please do not use vinegar but a commercially
available decalcification agent on the basis of
citric acid. Only use the quantities stated in the
instructions.

Cleaning


NOTE:
After descaling the device boil fresh water in it
several times (approximately 3-4 times) in order to
remove any residues. Do not consume this water.

Troubleshooting

• It is not possible to switch the machine on.
Possible Cause:
The appliance has no power supply.
Remedy:
- Check the socket with another appliance.
- Plug in the mains plug correctly.
- Check the main circuit breaker.
Possible Cause:
The appliance is faulty.
Remedy:
Contact our service center or a specialist.
Possible Cause:
After being used without or with too little water
the machine has not cooled down sufficiently.
Remedy:
Allow the machine to cool down for 15 min.
• The kettle shuts off prior to boiling.
Possible Cause:
The heated base is coated with too much lime
or the circuit of the plug is overloaded.
Remedy:
- Descale the machine as instructed.
- Check the mains connection.
49