Chicco LIVING Instrucciones De Uso página 25

fixture (diagram 19) to adjust the leg rest to the required
position.
REMOVABLE BUMPER BAR
20. To remove the bumper bar, press the two buttons found
under the armrests (diagram 20) and pull the bar towards
you. Open one side of the bumper bar only to seat the child
in the stroller more easily.
WARNING: Always restrain the child using the safety har-
ness The bumper bar is NOT a child restraint device.
WARNING: never use the bumper bar to lift the stroller up
with the child sat in it.
ERGONOMIC HANDGRIP
ADJUSTABLE DOUBLE TWIST
21. Press the button on the handgrip to rotate the handgrip
into the required position, according to the height and
position most suited to the user (diagram 21).
The handgrip can be adjusted to 8 different positions.
22. WARNING: when using the stroller, the handgrips must
not be in the DOWN position (diagram 22 A). Make sure
that the handgrips are locked in the UP position, as seen
in diagram 22 B.
PARKING BRAKE
The parking brake is applied to both rear wheel at the same
time. To make it easier to use the stroller, a special STOP
& GO braking system has been installed, indicated by the
coloured stickers on the rear brake lever.
23. To put on the brakes, press the right lever downwards
(diagram 23). A red STOP sticker will appear and the op-
posite lever will move upwards.
24. To release the brakes, press the left lever downwards
(diagram 24). A green GO sticker will appear and the op-
posite lever will move upwards.
WARNING: Always apply the brakes whenever the stroller
is stationary. Never leave the stroller on a sloping surface
with a child inside, even with the parking brake ON.
WARNING: After applying the brake lever make sure that
the brakes are properly applied on both of the rear wheel
units.
SWIVEL WHEELS
The stroller has swivel/fixed front wheels. It is recommended
to use the fixed wheels on particularly uneven ground. It
is recommended to use the swivel wheels on normal road
surfaces as it makes it easier to handle.
25. To switch the front wheels to swivel mode, press the
front lever down with your front, as seen in diagram 25.
To switch back to fixed mode, pull the lever up with your
foot. Whatever the current position of the wheel, it will
lock in a straight position.
WARNING: Both wheels must be blocked or released at
the same time.
CLOSING THE STROLLER
WARNING: when opening the stroller, ensure that your child
and all other children are at a safe distance. Ensure that
during these operations the moving parts of the stroller do
not come into contact with your child. The stroller can be
closed when in either parent-facing or front-facing mode.
The instructions to follow are the same for both user modes.
If you wish to reduce the space the closed structure takes
up, it is recommended to close the structure with the seat
fitted in the front-facing position.
26. Raise the side compasses and fold the hood (diagram
26).
27. Pull both the small levers on the handles; keep them
raised whilst you use your toe to pull the rear cross frame
upwards (diagram 27).
28. Grasp the closure handle and pull it upwards until the
stroller locks into a closed position (diagram 28).
29. To decrease the space the closed stroller takes up, recline
the backrest as flat as possible (diagram 29 A – front-facing
diagram 29 B – parent-facing).
30. Now fold the handgrips forwards (diagram 30). When
the stroller is closed and locked in place, it will stand up
on its own
WARNING: You must always remove the joinable handle
(if fitted) before closing the stroller.
REMOVABLE COVERS
Open the stroller slightly with the safety harness unfas-
tened:
31. Release press stud A and the velcro fastener B as
indicated in diagram 31.
32. Raise the leg rest, release the buttons on the seat and
slide the lining off, paying attention to the harness straps
(diagram 32 A); remove the lining from the backrest by
pulling it upwards after undoing the side Velcro fasteners
(diagram 32 B).
USING THE CHILD CAR SEAT AND CARRYCOT
The CHICCO strollers which use the CLIK CLAK system
on the armrests allow you to fasten the carrycot and/
or child seat to the stroller frame without any need for
additional fixtures.
Please consult the relative instructions for information on
how to fit and remove the carrycot or child seat.
33. Before fitting the child car seat or carrycots, remove
the top section of the arm covers or remove the arms
completely (diagram 33 A and B).
WARNING: only the CHICCO child seats and carrycots
which are fitted with the CLIK CLAK system can be fitted
onto the stroller. Before using the stroller in combination
with the carrycot or child car seat, always check that the
hook-on system is correctly closed and locked in place.
ONLY USE ACCESSORIES FITTED WITH THE RELATIVE
CLIK CLAK DEVICE.
34. WARNING: Incorrect fastening of the accessory to the
stroller frame can cause the fastening system to malfunc-
tion, making it impossible to remove it. In this case you can
manually release the accessory by using a screwdriver on
the levers under the armrests which can be reached through
the relative slot (diagram 34).
ACCESSORIES
WARNING: The accessories described below are not nec-
essarily present on some versions of the product. Please
read the instructions relative to the accessories fitted on
the type of stroller you purchased carefully.
JOINABLE HANDLE
35. To fit the joinable handle, press the two central levers
inwards at the same time (see diagram 35 A) and connect
the hooks A and B into the relative holes (diagram 35 B),
until you hear them click into place.
36. To remove the joinable handle, press the two central
levers inwards at the same time (see diagram 36 A) and
slide the handle upwards (diagram 36 B).
WARNING: before using the product in the "joined handle"
mode, always check that it has been fitted correctly.
WARNING: You must always remove the joinable handle
before closing the stroller.
WARNING: never use the joinable handle to lift the stroller
up with the child sat in it.
25