Placing Combination Oven Into Cabinet Opening; Installing The Oven Into The Cabinet; Re-Install The Lower Oven Door; Before Calling Service - Bosch HSLP751UC Manual Del Usuario

Placing Combination Oven Into Cabinet
Opening
CAUTION
9
To avoid damage to the door, do not lift, pull or
push the unit during installation by using any oven
door handle as a gripping point.
When lifting the combined unit into place, avoid grasping
the upper element to avoid damaging it. See the
illustration below for the correct lifting point. This
illustration shows a detailed view of the oven cavity. Note
the location of the ridge inside the top of the cavity. This
is the area to grip from the front when lifting the
combined unit.

Installing the Oven into the Cabinet

Lift the combination oven unit into the cabinet cutout
1.
without allowing the unit base to contact the flooring.
Guide the unit straight back into the cabinet cutout.
2.
Note: Be careful not to crimp the flexible conduit
between the oven and the cabinet back wall. If
necessary, guide the flexible conduit into the wall of
cabinet access hole so it doesn't prevent the unit from
being pushed all the way into the cabinet opening. The
oven should be straight and level.
Push the unit straight in until the oven trim is flush with
3.
the front of the cabinet trim.
Install four (4) supplied screws through tap holes in
4.
the right and left trim pieces to secure oven to
cabinetry.
16

Re-Install the Lower Oven Door

Hold the door firmly in
both hands.
Hold the door at an 30°
angle from the closed
position (approximately 7
inches open at the top).
Insert the hinges into the
slots.
You may need to rock the
door forward and back-
ward slightly to seat the
hinge feet. The door
should lower about 3/4"
and stop. If not, the
hinges have not engaged
properly and the door
could fall if it is released.
The door may need to be
removed and re-inserted
until the hinges sit cor-
rectly in the slots.
Open door all the way to
expose hinges, latch
levers and slots.
Push latch levers up until
they are locked into the
slots, flush with front of
the oven body.
Close and open door
slowly to be sure it is cor-
rectly and securely in
place. Door must be
straight.

Before Calling Service

See the Use and Care Manual for each unit of the
combination oven for troubleshooting information. Refer
to the Statement of Limited Warranty in the Use and Care
Manuals.
To reach a service representative, see the contact
information at the front of the Use and Care Manual.
Please be prepared with the information printed on your
product data plate when calling.