Intended Use - Kratki ARKE Serie Manual Del Usuario

materials, protected against oxidation (enamelled or steel flue pipe).
If the flue produces weak draught, consider laying new pipes. It is also important for the flue not to
produce excessive draught, you must then install a draught stabilizer in the flue. Alternatively, there
are also special flue endings regulating draught. Flue inspection should be carried out by a specialist
and any modifications can be made by an authorized company so that they fulfilled the requirements
in force in the given country.

INTENDED USE

The fireplace inserts manufactured by Kratki.pl use solid fuels with manual feeding fuel and lockable
doors. They are designed for trimming or locating into a niche. Hardwood to be burnt includes: horn-
beam, oak, beech, acacia, elm, maple, birch, with a moisture content of <20% (lignite briquettes and
wood briquettes are also acceptable).
They serve as an additional source of heat in the rooms in which they are installed.
The housing should be designed so that the fireplace insert was not permanently attached to it, while
retaining the possibility to install and remove the trim without damaging or breaking it. In addition,
it should provide access of the air needed for combustion and ventilation through the use of suitable
grilles and easy access to the exhaust throttle or chimney draft regulator (if installed).
INTRODUCTORY INFORMATION
In order to avoid the danger of fire, the fireplace insert must be installed in accordance with the
relevant building codes and the technical instructions given in this installation and use manual.
The design of the fireplace installation should be performed by a qualified specialist.
Before starting to use, develop a technical acceptance protocol which must be accompanied by
a positive opinion of a chimney specialist and a fire specialist.
a) Before installing a fireplace insert have an expertise executed and commissioning of the flue in
terms of its technical characteristics and the technical condition - leaks, blockages.
b) Installation and commissioning of the fireplace insert should be done by an installation company
having adequate licenses for this purpose and experience.
c) The fireplace insert should be located as close to the flue as possible. The room in which it will be
installed must have an efficient ventilation system and the necessary amount of air required for the
proper functioning of the insert.
d) While moving, do not grab the handle of the insert, as it may get damaged
e) Before using the insert, remove stickers from the glass
f ) Technical parameters of the insert apply to the fuel specified in this manual.
g) It is essential to comply with flue service intervals (at least 2 times a year).
h) Pursuant to the current law, a fireplace can not be the sole source of heat but it can only supplement
the existing heating system. The reason for this type of regulation is the need to ensure the heating
of the building in the event of prolonged absence of people.
Installation of a fireplace insert must be carried out in accordance with the provisions of standards in
force in this field, the requirements of construction law and the applicable fire safety standards. De-
tailed regulations concerning the safety of construction, fire safety and the safety of use are included
in the regulations and building regulations in force in the given country.
SELECTION OF FUEL
Fuel recommended
NOTE!
15