JB Systems Light TUBELED INDOOR Manual De Instrucciones página 4

ENGLISH
2. TUBELED SIGNAL OUTPUT: low voltage signal output to be connected with the signal input of the next
tube. Extra 0,8m, 5m or 10m signal cable extensions are optionally available.
3. POWER INPUT CABLE: To be connected with power output cable of the previous tube or directly with
one of the 2 outputs on the power supply.
4. POWER OUTPUT CABLE: To be connected with the power input cable of the next tube.
5. TUBE HOLDERS: Needed to fix the tubes easily against a surface.
6. GROUND CONNECTION: Use this connection to ground the led tubes properly.
7. PLASTIC COVER: The milky white plastic cover is used to mix the 3 primary colors. If you like you can
install the TUBELED tubes behind a big milky white opaque surface to create an "ever color changing
wall". In this case we suggest to remove the plastic cover from the TUBELED to obtain more light output.
This can be easily done by removing the 2 small screws on both sides of the plastic cover. Once the end
caps removed you can easily remove the plastic cover.
DESCRIPTION POWER SUPPLY
1. POWER SUPPLY OUTPUT CABLE 1: To be connected with the power input cable of the first tube in a
series of 8 tubes.
2. POWER SUPPLY OUTPUT CABLE 2: To be connected with the power input cable of the first tube in a
second series of 8 tubes.
3. GROUND CONNECTION: Use this connection to ground the power supply properly.
4. MAINS INPUT CABLE: To be connected to the mains 230Vac.
5. FUSE HOLDER: to be equipped with a 4A/250V slow blow fuse.
6. POWER SWITCH: used to switch the power supply on/off.
JB SYSTEMS®
INSTALLATION MANUAL
3/24 TUBELED™ INDOOR 12V
ENGLISH
INSTALLING:
 Fix all the tubes and power supplies properly, using the supplied holders.
 Connect the signal cables of
all tubes together. Make sure
to fasten the plastic ring well.
 Connect the power cables of
all tubes together. Make sure
to fasten the plastic ring well.
Important: You can put maximum 8
tubes to a each output of the power
supply. (Max. number of TUBELED
tubes: 2x8 = 16)
 Connect the signal input cable of the
first tube to the signal output connector
of the TUBELED™ controller.
Eventually use the optional 5m or 10m
extension cables.
 If you install more than 16 tubes, you
can daisy chain up to 4000 tubes on 1
controller but make sure to use one
power supply for every 16 tubes.
 Switch the controller and the power
supplies on and follow the "first time
setup" procedure in the user manual
supplied with the controller.
 Done!
SPECIFICATIONS
Mains Input: 12Vdc
Power consumption: 12Watt
Protection grade: IP33
Number of LEDs: 144 pcs (48 red, 48 green, 48 blue)
Life span of LEDs: 50000 ~ 100000 hours
Size: 1000 x 50 x 75mm
Weight: 1.6kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
JB SYSTEMS®
INSTALLATION MANUAL
4/24 TUBELED™ INDOOR 12V