Dirt Devil NAVIGATOR Manual De Instrucciones página 48

5 Use
5.2 Switching between power or silent mode
24
HOUR
18
5.3 Erecting a light fence
19
5.4 Erecting a smart fence
24
HOUR
20
48
After starting, the robot cleans in power mode.
1. Press the "
" key on the remote control
once to enable silent mode if necessary.
2. Press the button again to switch back to
power mode.
NOTE:
Once you have chosen the power mode,
the suction rate and working speed are
higher than in silent mode and therefore
your robot consumes more electricity.
Proceed as follows to erect a light fence:
1. Set the light fence tower in a place that
your robot will not pass (Fig. 19).
2. Switch the light fence tower's power
switch to "On".
- The tower's LED is lit and then blinks.
- An invisible light fence is built up.
3. Now power on the robot. It will not pass
the fence.
1. Erect a light fence as described in
Chapter 5.3, "Erecting a light fence".
2. Press the "
" key on the remote control
to activate smart fence.
- A short beep occurs.
- An invisible smart fence is built up.
3. Now power on the robot. Your robot will
completely clean the room it is in. Then it
will pass the light fence to clean the adja-
cent room.
NOTE:
To deactivate the smart fence function,
press the " " key again. You will hear
two short beeps.