Tabla de contenido
Idiomas disponibles
Idiomas disponibles
4. Insert two s crews into t he screw h oles.
5. Secure
shoulder
strap clamp by tighten-
ing screws with a hex w rench.
ADJUSTING
THE ASSIST HANDLE
_WARNING:
When adjusting
the as-
sist handle,
be sure it remains
between
the
coupler
and the _11 lower arrow (closest
to
coupler)
on the safety label to ensure proper
balancing
of unit. When
adjusting
the assist
handle or handlebar
during use of optional at-
tachments,
it must be repositioned
between
the throttle
trigger and the
I_ upper arrow
(closest
to engine) on the safety label.
1.
Loosen wing nut on handle.
2.
Rotate the handle on the shaft to an up-
right position;
retighten
wing nut.
KNOW YOUR PRUNER
READTHIS INSTRUCTION MANUAL AND SAFETY RULESBEFORE OPERATING YOUR UNIT
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments.
Save this manual for future reference.
Pruner
/
Shaft
Attachment
Hanger
Bar oil fill cap
Chain
_/
Assist Handle
Coupler
_
/
Shoulder
strap clamp
Starter handle
Throttle
trigger
Switch
Fuel mix
fill cap
Primer
bulb
Bar
Bar nut
Start lever
Muffler
ON/OFF
SWITCH
The ON/OFF
switch
is located on the trigger
handle and is used to stop the engine. Move the
switch to the OFF position to stop the engine.
PRIMER
BULB
The PRIMER BULB removes
air from the car-
buretor and fuel lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the starter rope. Activate
the primer
bulb by pressing
it and allowing
it to return to
its original form.
START
LEVER
The START LEVER helps to supply fuel to the
engine to aid in starting. Activate
the starting
system by moving the start lever to the START
position. DO NOT squeeze
the throttle trigger
until the engine has started and runs. After the
engine starts, allow the engine to warm-up
5
seconds, then fufly squeeze
the throttle trigger
to deactivate the starting system.
COUPLER
The
COUPLER
enables
optional
attach-
ments to be instafled
on the unit.
CHAIN
TENSION
it is normal for a new chain to stretch during
first
15 minutes
of operation.
You should
check
your
chain
tension
frequently.
See
CHAIN
TENSION
in the SERVICE
AND AD-
JUSTMENTS
section.
BEFORE STARTING
ENGINE
_
WARNING:
Be sure to read the fuel
information in the safety rules before you be-
gin. if you do not understand the safety rules,
do not attempt to fuel your
unit. Call
1-800-554-6723,
FUELING ENGINE
_
WARNING:
Remove fuel cap slowly
when refueling.
HELPFUL TIP
I
\ T°°btainthec°rrect°ilmix
I
) ratio, PoUr 3.2 ounces of
I
2-cycle
synthetic
oil into
one gallon of fresh gas.
This
engine
is
certified
to
operate
on
unleaded
gasoline.
Before
operation,
gasoline
must be mixed with a good quality
synthetic
2-cycle
air-cooled
engine
oil
designed
to be mixed
at a ratio
of 40:1.
Poulan/WEED
EATER brand synthetic
oil is
9
Tabla de contenido
