Cleaning And Maintenance; Troubleshooting Guide - essentiel b ECHSC1b Instrucciones De Uso

"ECO" mode
The heater automatically adjusts the heating power as follows:
When room temperature is below 18°C, the heater runs on high power.
•
When room temperature is 18°C to 22°C, the heater runs on medium power.
•
When room temperature is above 22°C, the appliance stops heating.
•
Press the "ECO" button to activate/deactivate the "ECO" mode.
•
You cannot change the temperature setting when the "ECO"mode is activated.
•
When you have finished
When you have finished, press the
1.
Set the "I/0" on/off switch to position "0" (off) and unplug the appliance from the power
2.
socket.

cleaning and maintenance

IMPORTANT:
Always unplug the power cord from the power
•
socket and allow the appliance to cool down before
cleaning or maintaining it.
Never immerse the plug, power cable or appliance
•
in water or any other liquid.
Never use abrasive cleaning products (alcohol,
•
solvent) or aerosol products on this appliance.
Use a soft, dry cloth to remove dust and clean the exterior surfaces of the appliance.
•
For thorough cleaning, you can use a soft cloth lightly soaked in water and a mild detergent
•
(such as washing up liquid). Then dry thoroughly with a soft cloth before turning the
appliance back on.
Make sure no water ever enters the appliance through the air vents.
•
A dusty grille can cause the appliance to overheat. If dust accumulates on the ventilation
•
grilles, use a vacuum cleaner to remove it.
If you do not use the appliance for a long period of time, unplug it from the power socket.
•
36
V.2.0
use
button to put the appliance on standby.

troubleshooting guide

Problem Possible cause
The appliance is unplugged.
The "I/0" on/off switch at the
The heater is not
rear is in position "0" (off).
working.
The appliance is in standby
mode.
When room temperature
reaches the requested
temperature, the heater
stops heating. When room
The appliance does not
temperature drops, the heater
produce any heat.
starts heating again.
The "ECO" modeis selected.
The appliance is overheating.
A piece of clothing covers the
heater or dust obstructs the
The appliance suddenly
ventilation grilles.
stops working.
The appliance has tipped
over.
CAUTION: do not attempt to repair the appliance
yourself. If the problem persists, contact your retail
store's customer service department.
Solution
Plug the appliance into a
mains socket.
Set the on/off switch to
position "I" (power on).
Press the button to turn
on the appliance.
However, you can increase
the requested temperature
using the "+" button.
Deactivate the "ECO" mode
by pressing the "ECO"
button.
Remove the piece of clothing
obstructing ventilation and/
or use a vacuum cleaner
to remove dust from the
ventilation grilles.
Turn off and unplug the
appliance, allow it to cool
down for a while before using
it again.
The anti-tilt safety device has
been activated. Put the heater
back up.
37
V.2.0
troubleshooting guide