Cleaning Instructions; Boiling Chamber; Water Bottle; Outside Surfaces - SciCan AQUASTAT W 10000 Instrucciones De Uso

Cleaning Instructions

8. Slide the boiling chamber into the distiller chassis and press firmly to
insure that it
is properly placed. It is important that the boiling chamber be pressed
firmly into the distiller chassis. It is recommended that you place one
hand on the back of the distiller chassis and push the boiling chamber
into the chassis with the other hand. To ensure
that a tight electrical connection is made, press on the base of the
boiling chamber near the start button also.
CAUTION: To prevent personal injury or property damage, the boiling chamber
must be fully
engaged prior to start-up.
9. Press the "start" button at the base of the boiling chamber.
NOTE: The button will glow when the boiling chamber is heating, however, the
light will go out
and the boiling chamber will stop heating if electrical
power to the boiling chamber is interrupted or stopped. If this occurs, press the
start button
again to restart the distillation cycle.
10. The cooling fan will not start immediately.
A delayed fan startup feature has been included
in your distiller. The fan will start once the
boiling chamber has reached a pre-determined temperature,
approximately 30-40 minutes after starting the cycle.
NOTE: Do not install the cap onto the water bottle.
The bottle must be left uncapped to allow water to enter
it from the distiller.
11. Make sure that the dispensing valve is securely tightened onto the

water bottle.

12. Place the water bottle on the base of the distiller chassis. The base of
the distiller chassis has raised edges to assist in positioning the water
bottle properly.
NOTE: Do not remove the water bottle while the distiller is running.
13. At the end of the distillation cycle (about 4 to 4
will shut off automatically and the "start" light will go out. The fan
Use and Care Guide
hours), the distiller
1 ⁄ 2
8