Cleaning The Outside Of The Appliance; Cleaning The Fl Oor Nozzle; Replacing The Exhaust Fi Lter; Troubleshooting - Panasonic MC-CG524 Instrucciones De Funcionamiento

WARNING
− Remove the plug from the socket outlet before cleaning or maintaining the
appliance.
CAUTION
− Do not use detergent or any other cleaning liquids.

Cleaning the outside of the appliance

Clean the outside of the appliance with a soft cloth.
Cleaning the fl oor nozzle
Use an old tooth brush or similar tool to clean any dirt or lint from the brush.
MC-CG524 MC-CG522
CAUTION
Do not wash the fl oor nozzle with water.
Replacing the exhaust fi lter
Replace the exhaust fi lter once a year.
Detach two tabs of body cover from the rear side and replace the fi lter with a new one.
Put the body cover back to the main body.
Please check the following fi rst if you have any problems.
Problem
The appliance does not switch on.
The mains lead does not come out.
The mains lead does not fully rewind.
Suction power has decreased.
If the problem cannot be solved, please contact your local customer service centre. The contacts can be found in "GUARANTEE", the separate paper which has
been attached with the appliance.
MAINTENANCE
Flat surface
face down
or
MC-CG524 MC-CG522

TROUBLESHOOTING

Solution
− Check if the plug is connected fi rmly and the socket outlet is working normally.
− If a thermal cut-out device has activated, wait approximately 60 minutes until it has reset.
− Rewind and pull out the mains lead repeatedly while pressing the cord rewind pedal without using
excessive power.
− Pull the mains lead out 2 m to 3 m and then press the cord rewind pedal to rewind the mains lead
while holding the plug.
− Check if the dust bag is full.
− Check for blockages in hose, telescopic wand, nozzles and pre-motor fi lter. Then clean those parts as
necessary.
Maintaining the pre-motor fi lter
1. Remove the dust bag. (see replacing the dust bag)
2. Remove pre-motor fi lter from its slot, wash gently with water and then allow
it to dry in shaded area.
3. Replace all parts to their original positions.
If the dust bag is not properly installed, the dust cover cannot be closed.
1. 2.
CAUTION
Attach the pre-motor fi lter correctly to avoid damaging motor.
Specifi cations
Power source
Max input
Nominal input
Dimensions (W x L x H)
Net weight
Extension wands
Floor nozzle
Crevice nozzle
Dusting brush
* Class with respect to protection against electric shock:
3.
MC-CG524 MC-CG522
230 V ~ 50 Hz
1400 W 1300 W
1300 W 1250 W
304 mm x 450 mm x 240 mm
4.5 kg
Telescopic
√
√
√
23