Programming Functions - electrovolta 900CT-380 Manual De Instrucciones

PROGRAMMING FUNCTIONS

Access the parameter menu by holding the P2 ENTER button until the first parameter, C, appears. Press the
ENTER button (P2) repeatedly to advance through the parameters menu. To change the parameter press ↕
UP/DOWN (P1)
NB: Functions E/F/L/R are present only on versions 900CT-380/900CT-381
FUNCTIONS \ VALUES
c
AUTOMATIC CLOSURE
(seconds)
d
STEP BY STEP
COMMAND P/P
E
%DECELERATION
F
ELECTROBRAKE
H
CONDOMINIUM (OPEN
ONLY)
L
MOTOR FORCE
o
CLOSE AFTER TRANSIT
P
TIMER/MAGNETIC COIL
ON STEP/STEP
r
SOFT START DELAYED
START TIME
T
TYPE OF SLOWING
DOWN
U
MAN PRESENT
y
PRE-FLASHING
N.B.: any variation in function must be made with the automation closed
Once the parameters have been displayed, the total manoeuvres counter are shown in two different screens,
where the thousand units are indicated by the lighting up of the point. To reset this counter, simultaneously
press and hold buttons P1 and P2 (ENTER/UP-DOWN) until 0000 is displayed
N.B. If the point of the LCD on the left lights up, it means that 10,000 manoeuvres have been exceeded,
which must be added to the value shown.
To exit parameter display, press ENTER several times until automatic closure condition is shown ( -- two
dashes).
0 1 2
NO 5 10
Open By activating the step/step function, you avoid passage of the
Open
Stop automation in the stop state. The enabled function may be critical for
Close
close
NO 10% 20%
By activating the electrobrake function through the F parameter, a heavy
gate is prevented from continuing its movement, due to its inertia, for a
NO YES
few seconds instead of stopping it instantenously following a command
Activate the condominium function so that the first step/step impulse
NO YES
100% 10%
20%
Max Min
When you activate the Close After Transit function with automatic
NO YES closure activated, the automation is closed in the shortest time possible
When you activate the function Timer / Magnetic Coil via parameter P
after terminating total opening if step/step contact N.15 is kept closed the
automatic closing time is locked so that the gate never closes until the
NO YES
step/step contact is opened again, if there are several step/step impulses
during the standby time for automatic closing the time will be
When you activate the Soft Start function, during the first seconds of
NO YES movement of the automation the control unit keeps the motor at reduced
2500Kg 4000Kg
(SC-240) (SC-400)
When you activate the Man Present function via parameter U, you can
open the automation until step/step contact N.15 is closed and close the
NO YES
automation until contact PED n.14 is closed; when the two contacts are
NO 1sec 2sec
17
3 4 5 6
15 20 25 30
automations with high inertia.
When the deceleration function is activated in the last
30% seconds of operation of the automation, the control unit
slows the motors based on the selected %.
or a safety action
opens and accepts only re-opening during closing
30% 40% 50% 60%
without waiting for automatic re-closing.
continuously reset
speed for a softer start.
Select the type of slowdown on the basis of
the gate
released the automation goes to STOP position.
When the pre-flashing function is activated, before any
4sec
movement the flasher is activated for the selected time
7 8 9 10
40 80 120
70% 80% 90%
GB
K