Troubleshooting; Warranty - Dometic GROUP WAECO PerfectView VT 100DIG Instrucciones De Montaje Y Del Uso

Troubleshooting

9 Troubleshooting
Fault
The monitor displays
the message "NO
SIGNAL".
The monitor displays
the message
"REVERSE FOR
IMAGE".
The monitor displays
the message "Pair-
ing Failed".
The monitor displays
the message "wait
for TX".
Irregular image play-
back or yellow warning
triangle on the screen.
10

Warranty

The statutory warranty period applies. If the product is defective, please contact the
manufacturer's branch in your country (see the back of the instruction manual for the
addresses) or your retailer.
For repair and guarantee processing, please include the following documents when you
send in the device:
 A copy of the receipt with purchasing date
 A reason for the claim or description of the fault
30
Cause
The transmitter mod-
ule is not working.
The green and the blue
cable are incorrectly
connected.
The transmitter mod-
ule is not receiving a
video signal.
The start signal (on/off
three times) is incom-
plete or missing.
Transmitter and
receiver modules have
lost identification.
The transmitter mod-
ule has no voltage sup-
ply.
–
Suggested remedy
Check the voltage supply.
Check the camera connection and
function.
Repeat the system pairing until the
monitor displays "Save data".
Engage reverse gear again.
Start system pairing.
Check the voltage supply.
Make sure that the antennae of the
receiver module and the transmitter
module are firmly connected.
Check the reception bars on the
monitor. If only one reception bar is
displayed, change the position of
the transmitter or receiver module.
Check if the battery charge is suffi-
cient.
VT100DIG
EN