Pairing The System - Dometic GROUP WAECO PerfectView VT 100DIG Instrucciones De Montaje Y Del Uso

VT100DIG
8

Pairing the system

NOTE
I
The transmitter module and the receiver module have to be paired with each
other so that the monitor can display the camera images. This is conducted at
the factory.
8.1 Pairing the system manually with the pairing button
➤ Press the pairing button on the receiver module (fig. 7 2, page 5) three times within
10 s (press the button approx. 1 time per second).
✓ The LED on the receiver module (fig. 7 3, page 5) flashes red.
✓ The monitor displays the message "Pairing Start" and a counter that counts down
50 s.
You need to perform the pairing of the transmitter module within 50 s.
➤ Press the pairing button on the transmitter module (fig. 6 2, page 5) three times within
10 s (press the button approx. 1 time per second).
✓ The LED on the transmitter module (fig. 6 3, page 5) flashes red.
✓ The modules synchronise themselves with each other.
This takes approx. three to five seconds. For successful pairing, the monitor shows
the "Save data" message and the picture appears.
If pairing is unsuccessful, the monitor displays the message "Pairing Failed".
Repeat the pairing procedure.
8.2 Pairing the system with reverse gear
You can start pairing the module via the reverse gear if you connect the red cable from
the transmitter module to the positive terminal and the green cable of both modules on
the reversing light.
➤ Switch on the monitor.
➤ Activate the required channel.
➤ Engage and disengage the reverse gear three times within 10 s.
✓ The LED on the transmitter module (fig. 6 3, page 5) and the LED on the receiver
module (fig. 7 3, page 5) flash red.
✓ The modules synchronise themselves with each other.
This takes approx. three to five seconds. For successful pairing, the monitor shows
the "Save data" message and the picture appears.
If pairing is unsuccessful, the monitor displays the message "Pairing Failed".
Repeat the pairing procedure.
EN
Pairing the system
29