Tabla de contenido
Idiomas disponibles
Idiomas disponibles
fg
ENGLISH
Technical Characteristics
Rated voltage:
Rated power input:
Load speed:
Drilling capacity up to:
Protection class:
Collet:
Weight:
Collar clamping diam.:
Diamond drill motors are designed for professionals and should only be used by authorized persons.
All rights of changes due to technical development reserved.
Safety Instructions
Read and obey these instructions before using this machine.
ADDITIONAL SAFETY RULES FOR THIS MACHINE
1.
Disconnect from mains supply whenever any work, servicing and adjustment or change of
accessories and cutters is required.
2.
Only grip by insulated part of auxiliary handle and other plastic surfaces when performing drilling
where cutter is likely to contact hidden electrical wiring or its own cable. Contact with a "Live"
wiring will make all exposed metal surfaces of the machine "Live" and danger for an electric shock.
3.
Before using the machine, inspect and check power cord and plug for signs of damage and if any
found, have these repaired or replaced immediately. Plug the cord in only after making sure that
mains switch is OFF.
4.
Machine should never be damp or wet. Do not use the machine in damp or wet locations.
5.
When working this tool always use auxiliary side handle and hold the machine firmly with both
hands. Keep secure stance.
6.
Do not leave the machine running unattended. Switch ON only when hand-held.
7.
Keep hands well away from rotating parts.
8.
Keep sure footing and body balance at all times for better control of reaction torque.
9.
For longer machine use, wear hearing protectors.
10.
Likewise it is recommended to wear safety helmet, safety glasses and/or face shield. Also wear a
dust mask and thickly padded gloves.
11.
Prior to work starting, make sure that cutting accessory is fitted properly.
12.
Before starting work carefully check all screws for tightness. Due to vibration screws come loose
and can cause serious breakdown or injury.
13.
Make sure no one is below when using the machine in high locations.
14.
Avoid touching near dry-cut immediately after work process. Area can be very hot and cause
severe burns.
15.
To avoid machine self-starting, always trigger-off the switch should power supply become
interrupted or plug accidentally withdrawn from the socket while motor is still running.
Main Instructions
Auxiliary Handle
In hard held drilling operations, only use the machine with the auxiliary handle fixed. This handle must be
tighten on the collar, by turning the lever.
110 V
1500 W
-1
0 – 2000 min
82 mm
II
M 18
3.4 kg
46 mm
Tabla de contenido
