DeWalt DWX726 Manual De Instrucciones página 7

FIG. 8
ATTACHING THE EXTENSION WORK SUPPORTS (FIG. 9, 10)
IMPORTANT: Be sure the longer side of the "T" in the work support
arm (B) is oriented down as shown in Figure 9. Refer to the label with
the arrow pointing down.
1. With the stand raised to desired height, place the top piece (H1)
of the work support into the top of the work support arm (B) hole.
Insert the bottom piece (H2) of the work support into the bottom
hole of the arm, with proper orientation to the top piece.
2. Tighten the vertical lock knob (F).
3. Repeat with the other extension work support.
V
I
I
V
E
4. Insert the assembled extension work support arm (B) with the
small black cap (inset, Fig. 10) into the hole (W) of the stand
closest to the red activating lever. Push the arm in to lock in place.
5. Repeat for other work support arm on opposite end. Push the arm
in to lock in place.
NOTE: The internal locking mechanism keeps the work supports from
disengaging.
FIG. 9
H1
B
F
H2
ATTACHING THE CORD WRAPS (FIG. 11, 12)
NOTE: Place the cord wraps (X) in opposite positions to hold the cord
securely.
1. Place the cord wrap screw (X) into the hole (Z) from outside of
stand. Place the washer and nut on cord wrap screw and finger
tighten nut.
5
FIG. 10
H
B
W