Intended Use - Makita TW001G Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Model:
Fastening capacities
Square drive
No load speed (RPM)
Impacts per minute
Max. fastening torque
(at max impact mode (4) )
Nut-Busting torque
(at max impact mode (4) )
Overall length
Rated voltage
Net weight
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• The weight may differ depending on the attachment(s), including the battery cartridge. The lightest and heavi-
est combination, according to EPTA-Procedure 01/2014, are shown in the table.
Applicable battery cartridge and charger
Battery cartridge
Charger
• Some of the battery cartridges and chargers listed above may not be available depending on your region of residence.
WARNING:
Only use the battery cartridges and chargers listed above. Use of any other battery cartridges
and chargers may cause injury and/or fire.

Intended use

The tool is intended for fastening bolts and nuts.
Noise
The typical A-weighted noise level determined accord-
ing to EN62841-2-2:
Sound pressure level (L
Sound power level (L ) : 111 dB (A)
WA
Uncertainty (K) : 3 dB(A)
NOTE: The declared noise emission value(s) has
been measured in accordance with a standard test
method and may be used for comparing one tool with
another.
NOTE: The declared noise emission value(s)
may also be used in a preliminary assessment of
exposure.
Standard bolt
High tensile bolt
Max impact mode (4)
Hard impact mode (3)
Medium impact mode (2)
Soft impact mode (1)
Max impact mode (4)
Hard impact mode (3)
Medium impact mode (2)
Soft impact mode (1)
Fastening with M30 for 6 seconds
Fastening with M30 for 3 seconds
) : 100 dB(A)
pA
D.C. 36 V - 40 V max
WARNING:
Wear ear protection.
WARNING:
The noise emission during actual
use of the power tool can differ from the declared
value(s) depending on the ways in which the
tool is used especially what kind of workpiece is
processed.
WARNING:
Be sure to identify safety mea-
sures to protect the operator that are based on an
estimation of exposure in the actual conditions of
use (taking account of all parts of the operating
cycle such as the times when the tool is switched
off and when it is running idle in addition to the
trigger time).
4 ENGLISH
TW001G
M12 - M36
M10 - M27
19.0 mm
-1
0 - 1,800 min
-1
0 - 1,400 min
-1
0 - 1,150 min
-1
0 - 950 min
-1
0 - 2,500 min
-1
0 - 2,400 min
-1
0 - 2,200 min
-1
0 - 1,900 min
1,800 N·m
1,500 N·m
2,050 N·m
217 mm
3.9 - 4.2 kg
BL4025 / BL4040
DC40RA