Disposal And Recycling; Storage; Troubleshooting - Gardol GET-E 4530 Manual De Instrucciones

•
Use a brush to remove deposits from the
safety guard.
8.2 Replacing the line spool (Fig. 14-16)
Important! Make sure that you pull out the
power plug before replacing the line spool!
•
Press the sides of the spool cover as shown
and remove the cover (Figure 14-15).
•
Remove the empty line spool.
•
Thread the ends of the line on the new line
spool through the eyelets in the spool recep-
tacle (Fig. 16).
•
Fit the spool cover back in the spool mount.
•
When you start the equipment again the line
will be cut to the perfect length automatically.
Caution! Bits of the nylon line could cause
injury when fl ung out!
8.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
8.4 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Spare line spool Art. no.: 34.051.42

9. Disposal and recycling

The equipment is supplied in packaging to pre-
vent it from being damaged in transit. The raw
materials in this packaging can be reused or
recycled. The equipment and its accessories are
made of various types of material, such as metal
and plastic. Never place defective equipment in
your household refuse. The equipment should
be taken to a suitable collection center for proper
disposal. If you do not know the whereabouts of
such a collection point, you should ask in your
local council offi ces.
Anl_GET_E_4530_SPK7.indb 19 Anl_GET_E_4530_SPK7.indb 19
GB

10. Storage

Store the equipment and accessories out of
children's reach in a dark and dry place at above
freezing temperature. The ideal storage tempe-
rature is between 5 and 30 °C. Store the electric
tool in its original packaging.

11. Troubleshooting

The machine will not work:
Check that the power cable is connected properly
and check the mains fuses.
If the machine will not work despite the voltage
supply being OK, send it to the specifi ed after-
sales service address.
- 19 -
16.12.2015 15:32:54 16.12.2015 15:32:54