John Bean B340 Manual Do Operador página 140

4
4
B
140
D R
7-7
U R
7-5
User Code
Measuring runs counter
Select the keys (4), (D) of Fig.7-7.
—
Example: 25 measuring runs so far performed (R).
The following counters can be displayed:
1 = Total number of measuring runs
2 = Total number of measuring runs where balance
result was considered OK
3 = Number of optimisations or minimisations
4 = Number of measuring runs in service mode
5 = Number of measuring runs since the last
calibration
6 = Number of wheel clamping cycles carried out
Every measuring run actually completed is stored.
Maximum count is 999,999 runs. Once this number is
reached, the counter is reset to zero. The information
is primarily useful for statistical purposes, e.g. to obtain
evidence of load intervals of parts when defective, or of
monthly (yearly) use of the machine, etc. The measuring
runs performed while the machine is on are transferred
into the permanent memory and added when it is
switched off. The counter cannot be reset.
Note: This a read-only screen; the data shown cannot
be changed.
Starting the measuring run by closing the wheel
guard (U, Fig. 7-5)
Select (Fig.7-5):
(4), (B), (U), (R).
—
Disabled = Start via START key
—
Enabled(*) = Start via wheel guard
—
After the confi rmation, this operating mode can
be acquired in the permanent memory (Fig. 7-6).
* = Factory confi guration