Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Service
Maintenance
General Recommendations
•
Always observe safety rules when
performing any maintenance.
•
The warranty on this chipper/shredder
vacuum does not cover items that have
been subjected to operator abuse or
negligence. To receive full value from
warranty, operator must maintain the
equipment as instructed here.
•
Changing of engine-governed speed will
void engine warranty.
•
All adjustments should be checked at
least once each season.
•
Periodically check all fasteners and make
sure these are tight.
WARNING:
Always stop engine,
disconnect spark plug, and ground
against engine before performing
any type of maintenance on your
machine.
Lubrication
1.
Lubricate each wheel shoulder screw (rear
wheel) and pivot arm axle (front wheel)
once per season with light oil.
2.
Lubricate the pivot points of the nozzle
height adjustment levers once a season
with light oil.
3.
Lubricate the locking rod with light oil to
ease the application of attaching on or
removing bag.
4.
Lubricate the nozzle/hose vac lever on
top of the nozzle once a season with light
oil. See Figure 5-1.
Figure 5-1
5.
Follow the separate engine manual
packed with your unit for lubrication
instructions.
Equipment Care
•
Clean the chipper/shredder vacuum
thoroughly after each use.
•
Wash bag periodically with water. Allow
to dry thoroughly in shade.
•
If the flail screen becomes clogged,
remove and clean as instructed below.
NOTE: Cleaning with a forceful spray of
water is not recommended as it could
contaminate the fuel system.
Engine Care
Refer to the Engine Operator's Manual packed
with your chipper/shredder vacuum for all
engine maintenance.
WARNING:
Before performing
any type of maintenance on the
machine, wait for all parts to stop
moving and disconnect the spark
plug wire. Failure to follow this
instruction could result in personal
injury or property damage.
Removing the Flail Screen
If the discharge area becomes clogged, remove
the flail screen and clean area as follows:
1.
Stop the engine. Make certain the
chipper/shredder vacuum has come to a
complete stop.
2.
Before unclogging the discharge chute,
disconnect and ground the spark plug
wire to retaining post.
3.
Remove the vacuum bag from the unit as
instructed in the OPERATION section to
obtain access to flail screen.
4.
Remove self tapping screw (a) on right
side of unit that attaches to the flail
screen. See Figure 5-2.
Figure 5-2
5.
Remove hex screw (b) on top of rear
housing near mounting bracket and
the flange lock nut (c) that secures flail
screen. See Figure 5-2.
6.
Remove and clean the screen by scraping
or washing with water. See Figure 5-3.
Figure 5-3
7.
Reinstall the screen.
Service
Blade Care
WARNING:
Before performing
any type of maintenance on the
machine, wait for all parts to stop
moving and disconnect the spark
plug wire. Failure to follow this
instruction could result in personal injury or
property damage.
NOTE: When tipping the unit, empty the oil and
fuel tank and keep engine spark plug side up.
6.
Disconnect and ground the spark plug
wire to retaining post.
7.
Remove bag assembly or blower chute.
8.
Remove the three hex cap screws holding
the chipper chute to the upper housing.
See Figure 5-4.
Figure 5-4
5
9
Tabla de contenido
Solución de problemas
