Troy-Bilt CSV 060 Manual Del Operador página 6

Bag
1. Grasp bag handle with one hand and slide
locking rod on mounting bracket with other
hand toward engine. Use the end of mounting
bracket as leverage when sliding the locking
rod. See Figure 3-6.
3
2
1
Figure 3-6
2. Slip bag over the rim of the discharge opening
and release locking rod to secure bag in place.
3. Snap bag clip to the top of the lower handle.
6. Place the lower straps on the bag over the top
of lower handle, hooking them on the studs.
See Figure 3-6.
NOTE:
The bag/chute switch button
attached to the mounting bracket must be
fully depressed by the tip of front tab on bag
handle when securing the bag or engine will
not start.
6 S 3 — A
ection SSembly
Adjustments
Nozzle Height
The nozzle can be adjusted to any six positions,
ranging from 5/8" to 4 1/8" ground clearance. The
nozzle height has to be adjusted according to
chipper shredder conditions.
7. Depress nozzle height adjustment lever
towards wheel. See Figure 3-7.
4
1. Move the height adjustment lever forward
or backward to adjust the nozzle upwards or
downwards. Make sure both levers are in the
same position.
2. Release lever towards deck. See Figure 3-7.
NOTE:
vacuum a thick layter of leaves. Lower the
nozzle height for smoother surfaces.
Set-Up
Gas and Oil Fill-Up
Refer to the separate engine owner's manual for
additional engine information.
1. Add oil provided before starting unit for the
first time out of the box.
2. Service the engine with gasoline as instructed
in the separate engine owner's manual.
& S -U
et p
2
3
1
Figure 3-7
In general, raise the nozzle height to
WARNING:
Use extreme care when
handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
Never fuel the machine indoors or while
the engine is hot or running. Extinguish
cigarettes, cigars, pipes and other sources
of ignition.
WARNING:
Never fill fuel tank indoors
with engine running or until the engine
has been allowed to cool for at least two
minutes after running.