Tabla de contenido
Idiomas disponibles
Idiomas disponibles
3.
Grasp bag handle with one hand and pull lock
rod on mounting bracket with other hand
toward engine to release.
4.
Lift bag off back of unit.
5.
Twist the two buttons on the back of the bag
to unlock and empty contents. See Figure 4-3.
Hold bag handle and bag clip while emptying
the contents.
Outer Flap
Figure 4-3
6.
Compress bag opening and fold inner flap
over opening.
7.
Fold outer flap over inner flap and insert
buttons on the bag through metal outlets. See
Figure 4-3.
8.
Twist the buttons to lock bag. Place bag back
onto unit as instructed in Assembly & Set-Up.
WARNING:
make any adjustments without first
stopping engine and disconnecting
spark plug wire.
8
S
4— c
ection
ontrolS
Using The Nozzle Vacuum
Yard waste such as leaves and pine needles can be
vacuumed up through the nozzle for shredding.
After material has been shredded by the flail blades
on the impeller assembly, it will be discharged into
catcher bag. Do not attempt to shred or chip any
material other than vegetation found in a normal
yard (i.e. branches, leaves, twigs, etc.) Avoid fibrous
plants such as tomato vines until they are thoroughly
dried out. Materials such as stalks or heavy branches
up to 1 1/2" in diameter may be fed into the chipper
chute.
1.
Place nozzle/hose vac lever in the top position
on the nozzle to vacuum through nozzle. See
Figure 4-4.
Buttons
Inner
Flap
2.
The spring loaded pin must be in the first hole
(closest to the end of the tube) of the hose
Do not at any time
adapter to operate the nozzle vac. See Figure
4-4.
3.
Place both hands on top of upper handle to
push unit over yard waste.
IMPORTANT: The flail screen is located inside
the housing in the discharge area. If the flail
screen becomes clogged, remove and clean as
instructed in Maintenance & Adjustments. For
best performance, it is also important to keep
the chipper blade sharp.
& o
peration
Figure 4-4
WARNING:
Do not attempt to
shred, chip, or vacuum any material
larger than specified on the machine
or in this manual. Personal injury or
damage to the machine could result.
Using The Hose Assembly
1.
Place nozzle/hose vac lever in the bottom
position on the nozzle to redirect vacuum to
the hose assembly. See Figure 4-5.
Figure 4-5
2.
The spring loaded pin must be in the second
hole of the hose adapter to operate the hose
assembly. See Figure 4-5.
3.
Unhook the hose from upper and lower hose
handle brackets and grasp the hose handle to
guide the hose while vacuuming yard waste
such as leaves or pine needles.
4.
If necessary, attach the hose extension to
vacuum in hard to reach places as follows:
a.
Insert round end of hose extension into
end of hose assembly.
b.
Secure strap on hose extension to pin
on hose assembly. See Figure 4-6.
A
Figure 4-6
B
Tabla de contenido
Solución de problemas
