Controls & Operation - Troy-Bilt CSV 060 Manual Del Operador

Controls & Operation
Recoil Starter
Hose Handle
Hose Extension
Controls
WARNING:
The operation of any
chipper shredder can result in foreign
objects being thrown into the eyes,
which can damage your eyes severely.
Always wear the safety glasses
provided with this unit or eye shields
while operating or while performing
any adjustments or repairs.
Chipper Chute
Allows twigs and small branches up to 1-1/2" in
diameter to be fed into the impeller for chipping.
Nozzle Height Adjustment Lever
Used to adjust the nozzle ground clearance ranging
approximately 5/8" to 4 1/8".
Nozzle
Yard waste such as leaves or pine needles can be
vacuumed up through the nozzle for shredding.
Chipper Chute
Nozzle Height
Adjustment Lever
Figure 4-1
Hose Assembly
Used as an alternative to the nozzle to vacuum yard
waste such as leaves or pine needles.
Hose Extension
Used to vacuum yard waste in hard to reach places
of yard.
Nozzle/ Hose Vac Lever
The nozzle/hose vac handle is located on top of the
nozzle. Use it to switch vacuum suction between the
nozzle and the hose assembly.
Hose Handle
Used to guide hose assembly when vacuuming.
Recoil Starter
The recoil starter is attached to the right upper
handle. Stand behind unit and pull the recoil starter
to start engine.
Bag
Nozzle/Hose
Vac Lever
Operation
Starting & Stopping Engine
Refer to the Engine Operator's manual packed with
your chipper/shredder vacuum for instructions on
starting and stopping the engine.
To Empty Bag
1. Unhook bag straps from the lower handle.
2. Unsnap bag clip from the top of lower handle.
See Figure 4-2.
3
4
Hose Assembly
Nozzle
2
4
1
Figure 4-2
7