Product Description And Specifications - Bosch PDA 180 Manual Original

Clean the air vents on your power tool regularly. The
u
motor's fan will draw the dust inside the housing and ex-
cessive accumulation of powdered metal may cause elec-
trical hazards.
Secure the workpiece. A workpiece clamped with
u
clamping devices or in a vice is held more secure than by
hand.
Always wait until the power tool has come to a com-
u
plete stop before placing it down.
Products sold in GB only:
Your product is fitted with an BS 1363/A approved electric
plug with internal fuse (ASTA approved to BS 1362).
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an au-
thorised customer service agent. The replacement plug
should have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Product Description and
Specifications
Read all the safety and general instructions.
Failure to observe the safety and general in-
structions may result in electric shock, fire
and/or serious injury.
Please observe the illustrations at the beginning of this oper-
ating manual.
Technical Data
Delta sanders
Article number
Rated power input
Power output
No-load speed
No-load orbital stroke rate
Orbit diameter
Sanding sheet length from corner to corner
Weight according to
EPTA-Procedure 01:2014
Protection class
The specifications apply to a rated voltage [U] of 230 V. These specifications may vary at different voltages and in country-specific models.
Noise/Vibration Information
Noise emission values determined according to
EN 62841-2-4.
Typically the A-weighted noise level of the power tool is:
Sound pressure level 80 dB(A); Sound power level
91 dB(A). Uncertainty K=3 dB.
Wear hearing protection
Bosch Power Tools
Intended Use
The power tool is intended for dry sanding and polishing of
wood, plastic, metal, filler and varnished surfaces. It is par-
ticularly well-suited for profiles, corners and hard-to-reach
areas.
Product Features
The numbering of the product features refers to the diagram
of the power tool on the graphics page.
(1) On/off switch
(2) Orbital stroke rate preselection thumbwheel
(PDA 180 E)
(3) Extraction outlet
(4) Sanding sheet
(5) Sanding plate
(6) SDS slider for sanding plate release
(7) Dust extraction hose
(8) Louvre sanding attachment
(9) Sanding sheet for sanding finger
(10) Sanding finger, flat
(11) Sanding finger, oval
(12) Handle (insulated gripping surface)
A) Accessories shown or described are not included with the
product as standard. You can find the complete selection of
accessories in our accessories range.
0 603 339 0..
W
W
−1
min
−1
min
mm
mm
kg
Total vibration values a
determined according to EN 62841-2-4:
2
a =6.5 m/s , K=1.5 m/s
h
The vibration level and noise emission value given in these
instructions have been measured in accordance with a
standardised measuring procedure detailed in EN 62841
and may be used to compare power tools. They may also be
used for a preliminary estimation of vibration and noise
emissions.
A)
A)
A)
A)
A)
A)
PDA 180
0 603 339 7..
180
80
9200
18400 13600–18400
1.5
92
1.1
/II
(triax vector sum) and uncertainty K
h
2
.
1 609 92A 4LA | (18.10.2018)
English | 11
PDA 180 E
180
80
6800–9200
1.5
92
1.1
/II