Setting The Sensitivity (Init Mode) - Dometic GROUP Waeco MagicSpeed MS880 Manual De Diagnóstico

MagicSpeed MS880
3.3

Setting the sensitivity (INIT mode)

In INIT mode you can set the sensitivity of speed reaction. If the speed reg-
ulator reacts to the speed too slowly you must increase the INIT value. If it
reacts too suddenly to the speed, you must decrease the INIT value.
➤ Start setup mode ("Starting setup mode" on page 19).
➤ To set the sensitivity, apply the brake and hold it down.
➤ With the brake applied, press the RES button three times.
✓ You will hear a low-pitched signal each time you press the button.
➤ Release the brake.
✓ You will hear three high-pitched signals.
NOTE
I
If you do not hear three signals, repeat the procedure.
➤ With the speed controller activated, drive at any speed above the activa-
tion speed (40 km/h).
➤ Press the SET button until the speed regulator takes on the speed you are
driving at.
➤ Switch off the speed regulator by applying the brake.
➤ Press the SET button.
✓ You will hear a high-pitched signal each time you press the button.
✓ The speed regulator gently takes on the speed.
NOTE
I
The normal functions of the SET and RES buttons are disabled in
this mode, which means you can use the buttons to make the set-
tings.
➤ If the reaction to the speed is too slow, press the SET button to increase
the INIT value.
➤ If the reaction to the speed is too sudden, press the RES button to de-
crease the INIT value.
✓ You will hear a low-pitched signal each time you press the button.
EN
Setting the sensitivity
21